Hi Conor: On 16:39 Thu 27 Jun , Conor Dooley wrote: > On Thu, Jun 27, 2024 at 03:31:14PM +0000, Yixun Lan wrote: > > SpacemiT K1 is an ideal chip for some new extension such as RISC-V Vector > > 1.0 and Zicond evaluation now. Add initial support for it to allow more > > people to participate in building drivers to mainline for it. > > > > This kernel has been tested upon Banana Pi BPI-F3 board on vendor U-Boot > > bootflow generated by Armbian SDK[1] and patched OpenSBI[2] to enable > > Zicboz, which does not in the vendor dts on its U-Boot. Then successfully > > booted to busybox on initrd with this log[3]. > > > > As previous discussion in patch v1[4], maintainer expect more basic drivers > > ready before really merging it, which would be fine. For other follow-up patches, > > that are clk, pinctrl/gpio, reset.. My current goal would target at a headless > > system including SD card, emmc, and ethernet. > > > > P.S: talked to Yangyu, I will help and take care of this patch series, thanks > > --- > > Changes in v2: > > - fix timebase-frequency according to current setting > > - add other uart dt nodes, fix input frequency > > - introduce new uart compatible for K1 SoC > > - add 'k1' prefix to bananapi-f3.dts > > - fix k1-clint compatible > > - fix some typos > > - Link to v1: https://lore.kernel.org/r/tencent_BC64B7B1876F5D10479BD19112F73F262505@xxxxxx > > I will take a closer look at this series later, but there's a few > patches here missing Acks that I gave alongside some nitpick remarks. > Could you look at v1 again and add those to whatever other comments I > leave when I take a closer look? > sure, thanks for your quick reply, I will do this tomorrow, and potentially wait all reviews, combine all tags I receive in v2, and address them in v3.. -- Yixun Lan (dlan) Gentoo Linux Developer GPG Key ID AABEFD55
