Trivia typo fixes: interupts --> interrupts and others.
Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
---
drivers/tty/serial/8250/8250_exar.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/tty/serial/8250/8250_exar.c b/drivers/tty/serial/8250/8250_exar.c
index 5405a1f463f1..ac373cde7e39 100644
--- a/drivers/tty/serial/8250/8250_exar.c
+++ b/drivers/tty/serial/8250/8250_exar.c
@@ -641,7 +641,7 @@ pci_fastcom335_setup(struct exar8250 *priv, struct pci_dev *pcidev,
* @port_num: Port number to set tristate off
*
* Most RS485 capable cards have a power on tristate jumper/switch that ensures
- * the RS422/RS485 transciever does not drive a multi-drop RS485 bus when it is
+ * the RS422/RS485 transceiver does not drive a multi-drop RS485 bus when it is
* not the master. When this jumper is installed the user must set the RS485
* mode to Full or Half duplex to disable tristate prior to using the port.
*
@@ -666,7 +666,7 @@ static int cti_tristate_disable(struct exar8250 *priv, unsigned int port_num)
* @priv: Device's private structure
*
* Some older CTI cards require MPIO_0 to be set low to enable the
- * interupts from the UART to the PLX PCI->PCIe bridge.
+ * interrupts from the UART to the PLX PCI->PCIe bridge.
*
* Return: 0 on success, negative error code on failure
*/
@@ -927,7 +927,7 @@ static int cti_port_setup_fpga(struct exar8250 *priv,
port_type = cti_get_port_type_fpga(priv, pcidev, idx);
- // FPGA shares port offests with XR17C15X
+ // FPGA shares port offsets with XR17C15X
offset = idx * UART_EXAR_XR17C15X_PORT_OFFSET;
port->port.type = PORT_XR17D15X;
@@ -1109,7 +1109,7 @@ static int cti_board_init_xr17v25x(struct exar8250 *priv,
priv->osc_freq = osc_freq;
- /* enable interupts on cards that need the "PLX fix" */
+ /* enable interrupts on cards that need the "PLX fix" */
switch (pcidev->subsystem_device) {
case PCI_SUBDEVICE_ID_CONNECT_TECH_PCI_UART_8_XPRS:
case PCI_SUBDEVICE_ID_CONNECT_TECH_PCI_UART_16_XPRS_A:
--
2.43.0.rc1.1336.g36b5255a03ac
