This series brings up initial support for the NXP S32G3 SoC, used on the S32G-VNP-RDB3 board [1]. The following features are supported in this initial port: * Devicetree for the S32G-VNP-RDB3 * UART (fsl-linflexuart) with earlycon support * SDHC: fsl-imx-esdhc (SD/eMMC) == Changes since v1 ==: * fix the reported checkpatch.pl errors. Two warnings still available but can be ignored * clean up unneeded DT nodes and properties * fix 'make dt_binding_check dtbs_check' errors * remove the S32 STMMAC driver and DT node which will be introduced in a new patchset * add NXP authorship and copyright into the dtsi header [1] https://www.nxp.com/design/design-center/designs/s32g3-vehicle-networking-reference-design:S32G-VNP-RDB3 Wadim Mueller (2): arm64: dts: S32G3: Introduce device tree for S32G-VNP-RDB3 dt-bindings: arm: fsl: Document missing s32g3 board and linflexuart .../devicetree/bindings/arm/fsl.yaml | 6 + .../bindings/serial/fsl,s32-linflexuart.yaml | 3 + arch/arm64/boot/dts/freescale/Makefile | 1 + arch/arm64/boot/dts/freescale/s32g3.dtsi | 236 ++++++++++++++++++ .../boot/dts/freescale/s32g399a-rdb3.dts | 43 ++++ 5 files changed, 289 insertions(+) create mode 100644 arch/arm64/boot/dts/freescale/s32g3.dtsi create mode 100644 arch/arm64/boot/dts/freescale/s32g399a-rdb3.dts -- 2.25.1
