Emil reports:
After updating Linux on an i.MX28 board, serial communication over
AUART broke. When I TX from the board and measure on the TX pin, it
seems like the HW fifo is not emptied before the transmission is
stopped.
MXS performs weird things with stop_tx(). The driver makes it
conditional on uart_tx_stopped().
So the driver needs special handling. Pass the brand new UART_TX_NOSTOP
to uart_port_tx_flags() and handle the stop on its own.
Signed-off-by: Jiri Slaby (SUSE) <jirislaby@xxxxxxxxxx>
Reported-by: Emil Kronborg <emil.kronborg@xxxxxxxxxxxxxx>
Fixes: 2d141e683e9a ("tty: serial: use uart_port_tx() helper")
Closes: https://lore.kernel.org/all/miwgbnvy3hjpnricubg76ytpn7xoceehwahupy25bubbduu23s@om2lptpa26xw/
---
drivers/tty/serial/mxs-auart.c | 5 ++++-
1 file changed, 4 insertions(+), 1 deletion(-)
diff --git a/drivers/tty/serial/mxs-auart.c b/drivers/tty/serial/mxs-auart.c
index 3ec725555bcc..4749331fe618 100644
--- a/drivers/tty/serial/mxs-auart.c
+++ b/drivers/tty/serial/mxs-auart.c
@@ -605,13 +605,16 @@ static void mxs_auart_tx_chars(struct mxs_auart_port *s)
return;
}
- pending = uart_port_tx(&s->port, ch,
+ pending = uart_port_tx_flags(&s->port, ch, UART_TX_NOSTOP,
!(mxs_read(s, REG_STAT) & AUART_STAT_TXFF),
mxs_write(ch, s, REG_DATA));
if (pending)
mxs_set(AUART_INTR_TXIEN, s, REG_INTR);
else
mxs_clr(AUART_INTR_TXIEN, s, REG_INTR);
+
+ if (uart_tx_stopped(&s->port))
+ mxs_auart_stop_tx(&s->port);
}
static void mxs_auart_rx_char(struct mxs_auart_port *s)
--
2.43.0
