Re: [PATCH 02/18] serial: sc16is7xx: fix invalid sc16is7xx_lines bitfield in case of probe error

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Tue, Dec 19, 2023 at 12:18:46PM -0500, Hugo Villeneuve wrote:
> From: Hugo Villeneuve <hvilleneuve@xxxxxxxxxxxx>
> 
> If an error occurs during probing, the sc16is7xx_lines bitfield may be left
> in a state that doesn't represent the correct state of lines allocation.
> 
> For example, in a system with two SC16 devices, if an error occurs only
> during probing of channel (port) B of the second device, sc16is7xx_lines
> final state will be 00001011b instead of the expected 00000011b.
> 
> This is caused in part because of the "i--" in the for/loop located in
> the out_ports: error path.
> 
> Fix this by checking the return value of uart_add_one_port() and set line
> allocation bit only if this was successful. This allows the refactor of
> the obfuscated for(i--...) loop in the error path, and properly call
> uart_remove_one_port() only when needed, and properly unset line allocation
> bits.
> 
> Also use same mechanism in remove() when calling uart_remove_one_port().

Yes, this seems to be the correct one to fix the problem described in
the patch 1. I dunno why the patch 1 even exists.

As for Yury's patch, you are doing fixes, so your stuff has priority on his.

-- 
With Best Regards,
Andy Shevchenko






[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux PPP]     [Linux FS]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Linmodem]     [Device Mapper]     [Linux Kernel for ARM]

  Powered by Linux