In serial_omap_rs485() RS485 support may be deactivated due to a missing
RTS GPIO. This is done by nullifying the ports rs485_supported struct.
After that however the serial_omap_rs485_supported struct is assigned to
the same structure unconditionally, which results in an unintended
reactivation of RS485 support.
Fix this by callling serial_omap_rs485() after the assignment of
rs485_supported.
Fixes: e2752ae3cfc9 ("serial: omap: Disallow RS-485 if rts-gpio is not specified")
Cc: stable@xxxxxxxxxxxxxxx
Signed-off-by: Lino Sanfilippo <l.sanfilippo@xxxxxxxxxx>
---
drivers/tty/serial/omap-serial.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
index 0ead88c5a19a..4f7ee4392034 100644
--- a/drivers/tty/serial/omap-serial.c
+++ b/drivers/tty/serial/omap-serial.c
@@ -1604,10 +1604,6 @@ static int serial_omap_probe(struct platform_device *pdev)
dev_info(up->port.dev, "no wakeirq for uart%d\n",
up->port.line);
- ret = serial_omap_probe_rs485(up, &pdev->dev);
- if (ret < 0)
- goto err_rs485;
-
sprintf(up->name, "OMAP UART%d", up->port.line);
up->port.mapbase = mem->start;
up->port.membase = base;
@@ -1622,6 +1618,10 @@ static int serial_omap_probe(struct platform_device *pdev)
DEFAULT_CLK_SPEED);
}
+ ret = serial_omap_probe_rs485(up, &pdev->dev);
+ if (ret < 0)
+ goto err_rs485;
+
up->latency = PM_QOS_CPU_LATENCY_DEFAULT_VALUE;
up->calc_latency = PM_QOS_CPU_LATENCY_DEFAULT_VALUE;
cpu_latency_qos_add_request(&up->pm_qos_request, up->latency);
--
2.40.1
