Simplify uart_get_rs485_mode() by using temporary variable for the GPIO descriptor. With that, use proper type for the flags of the GPIO descriptor. Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> --- drivers/tty/serial/serial_core.c | 30 ++++++++++++------------------ 1 file changed, 12 insertions(+), 18 deletions(-) diff --git a/drivers/tty/serial/serial_core.c b/drivers/tty/serial/serial_core.c index b32bbd7aa3d3..70bf2bec875c 100644 --- a/drivers/tty/serial/serial_core.c +++ b/drivers/tty/serial/serial_core.c @@ -3559,9 +3559,10 @@ int uart_get_rs485_mode(struct uart_port *port) { struct serial_rs485 *rs485conf = &port->rs485; struct device *dev = port->dev; + enum gpiod_flags dflags; + struct gpio_desc *desc; u32 rs485_delay[2]; int ret; - int rx_during_tx_gpio_flag; ret = device_property_read_u32_array(dev, "rs485-rts-delay", rs485_delay, 2); @@ -3600,26 +3601,19 @@ int uart_get_rs485_mode(struct uart_port *port) * bus participants enable it, no communication is possible at all. * Works fine for short cables and users may enable for longer cables. */ - port->rs485_term_gpio = devm_gpiod_get_optional(dev, "rs485-term", - GPIOD_OUT_LOW); - if (IS_ERR(port->rs485_term_gpio)) { - ret = PTR_ERR(port->rs485_term_gpio); - port->rs485_term_gpio = NULL; - return dev_err_probe(dev, ret, "Cannot get rs485-term-gpios\n"); - } + desc = devm_gpiod_get_optional(dev, "rs485-term", GPIOD_OUT_LOW); + if (IS_ERR(desc)) + return dev_err_probe(dev, PTR_ERR(desc), "Cannot get rs485-term-gpios\n"); + port->rs485_term_gpio = desc; if (port->rs485_term_gpio) port->rs485_supported.flags |= SER_RS485_TERMINATE_BUS; - rx_during_tx_gpio_flag = (rs485conf->flags & SER_RS485_RX_DURING_TX) ? - GPIOD_OUT_HIGH : GPIOD_OUT_LOW; - port->rs485_rx_during_tx_gpio = devm_gpiod_get_optional(dev, - "rs485-rx-during-tx", - rx_during_tx_gpio_flag); - if (IS_ERR(port->rs485_rx_during_tx_gpio)) { - ret = PTR_ERR(port->rs485_rx_during_tx_gpio); - port->rs485_rx_during_tx_gpio = NULL; - return dev_err_probe(dev, ret, "Cannot get rs485-rx-during-tx-gpios\n"); - } + dflags = (rs485conf->flags & SER_RS485_RX_DURING_TX) ? + GPIOD_OUT_HIGH : GPIOD_OUT_LOW; + desc = devm_gpiod_get_optional(dev, "rs485-rx-during-tx", dflags); + if (IS_ERR(desc)) + return dev_err_probe(dev, PTR_ERR(desc), "Cannot get rs485-rx-during-tx-gpios\n"); + port->rs485_rx_during_tx_gpio = desc; return 0; } -- 2.40.0.1.gaa8946217a0b