From: Hugo Villeneuve <hvilleneuve@xxxxxxxxxxxx>
The NXP-specific "irda-mode-ports" property lacks a proper vendor
prefix. Add "nxp," prefix to comply with DT best practises.
Signed-off-by: Hugo Villeneuve <hvilleneuve@xxxxxxxxxxxx>
---
.../devicetree/bindings/serial/nxp,sc16is7xx.txt | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt b/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt
index 1a7e4bff0456..d89815c5c562 100644
--- a/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt
+++ b/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt
@@ -21,8 +21,8 @@ Optional properties:
the second cell is used to specify the GPIO polarity:
0 = active high,
1 = active low.
-- irda-mode-ports: An array that lists the indices of the port that
- should operate in IrDA mode.
+- nxp,irda-mode-ports: An array that lists the indices of the port that
+ should operate in IrDA mode.
- nxp,modem-control-line-ports: An array that lists the indices of the port that
should have shared GPIO lines configured as
modem control lines.
@@ -80,8 +80,8 @@ Optional properties:
the second cell is used to specify the GPIO polarity:
0 = active high,
1 = active low.
-- irda-mode-ports: An array that lists the indices of the port that
- should operate in IrDA mode.
+- nxp,irda-mode-ports: An array that lists the indices of the port that
+ should operate in IrDA mode.
- nxp,modem-control-line-ports: An array that lists the indices of the port that
should have shared GPIO lines configured as
modem control lines.
--
2.30.2
