TX is handled by primary sequencer. After cancelling primary command, poll
primary sequencer's irq status instead of that of secondary.
While at it, also remove a couple of redundant lines that read from IRQ_EN
register and write back same.
Fixes: 2aaa43c70778 ("tty: serial: qcom-geni-serial: add support for serial engine DMA")
Signed-off-by: Vijaya Krishna Nivarthi <quic_vnivarth@xxxxxxxxxxx>
---
drivers/tty/serial/qcom_geni_serial.c | 7 ++-----
1 file changed, 2 insertions(+), 5 deletions(-)
diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c
index 3ca5db2..b8aa4c1 100644
--- a/drivers/tty/serial/qcom_geni_serial.c
+++ b/drivers/tty/serial/qcom_geni_serial.c
@@ -591,7 +591,6 @@ static void qcom_geni_serial_stop_tx_dma(struct uart_port *uport)
{
struct qcom_geni_serial_port *port = to_dev_port(uport);
bool done;
- u32 m_irq_en;
if (!qcom_geni_serial_main_active(uport))
return;
@@ -603,12 +602,10 @@ static void qcom_geni_serial_stop_tx_dma(struct uart_port *uport)
port->tx_remaining = 0;
}
- m_irq_en = readl(uport->membase + SE_GENI_M_IRQ_EN);
- writel(m_irq_en, uport->membase + SE_GENI_M_IRQ_EN);
geni_se_cancel_m_cmd(&port->se);
- done = qcom_geni_serial_poll_bit(uport, SE_GENI_S_IRQ_STATUS,
- S_CMD_CANCEL_EN, true);
+ done = qcom_geni_serial_poll_bit(uport, SE_GENI_M_IRQ_STATUS,
+ M_CMD_CANCEL_EN, true);
if (!done) {
geni_se_abort_m_cmd(&port->se);
done = qcom_geni_serial_poll_bit(uport, SE_GENI_M_IRQ_STATUS,
--
2.7.4
