The operating-performance-point vote needs to be dropped when shutting
down the port to avoid wasting power by keeping resources like power
domains in an unnecessarily high performance state (e.g. when a UART
connected Bluetooth controller is not in use).
Fixes: a5819b548af0 ("tty: serial: qcom_geni_serial: Use OPP API to set clk/perf state")
Cc: stable@xxxxxxxxxxxxxxx # 5.9
Cc: Rajendra Nayak <quic_rjendra@xxxxxxxxxxx>
Cc: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
Signed-off-by: Johan Hovold <johan+linaro@xxxxxxxxxx>
---
drivers/tty/serial/qcom_geni_serial.c | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c
index b825b05e6137..8be896dbaa88 100644
--- a/drivers/tty/serial/qcom_geni_serial.c
+++ b/drivers/tty/serial/qcom_geni_serial.c
@@ -126,6 +126,7 @@ struct qcom_geni_serial_port {
dma_addr_t rx_dma_addr;
bool setup;
unsigned int baud;
+ unsigned long clk_rate;
void *rx_buf;
u32 loopback;
bool brk;
@@ -1249,6 +1250,7 @@ static void qcom_geni_serial_set_termios(struct uart_port *uport,
baud * sampling_rate, clk_rate, clk_div);
uport->uartclk = clk_rate;
+ port->clk_rate = clk_rate;
dev_pm_opp_set_rate(uport->dev, clk_rate);
ser_clk_cfg = SER_CLK_EN;
ser_clk_cfg |= clk_div << CLK_DIV_SHFT;
@@ -1513,10 +1515,13 @@ static void qcom_geni_serial_pm(struct uart_port *uport,
if (new_state == UART_PM_STATE_ON && old_state == UART_PM_STATE_OFF) {
geni_icc_enable(&port->se);
+ if (port->clk_rate)
+ dev_pm_opp_set_rate(uport->dev, port->clk_rate);
geni_se_resources_on(&port->se);
} else if (new_state == UART_PM_STATE_OFF &&
old_state == UART_PM_STATE_ON) {
geni_se_resources_off(&port->se);
+ dev_pm_opp_set_rate(uport->dev, 0);
geni_icc_disable(&port->se);
}
}
--
2.41.0
