Gentle ping...
Best Regards
Sherry
> -----Original Message-----
> From: Sherry Sun
> Sent: 2022年11月28日 13:04
> To: gregkh@xxxxxxxxxxxxxxxxxxx; jirislaby@xxxxxxxxxx
> Cc: linux-serial@xxxxxxxxxxxxxxx; linux-kernel@xxxxxxxxxxxxxxx; dl-linux-imx
> <linux-imx@xxxxxxx>
> Subject: [PATCH] tty: serial: fsl_lpuart: don't enable receiver/transmitter
> before rx/tx dma ready
>
> lpuart32_setup_watermark_enable() will configure the UART FIFO and
> watermark, also enable the receiver and transmitter, this should be done
> after the rx/tx dma steup ready.
>
> Also add lpuart32_hw_disable() to make sure the receiver/transmitter and
> interrupts are disabled during the dma steup.
>
> Signed-off-by: Sherry Sun <sherry.sun@xxxxxxx>
> ---
> drivers/tty/serial/fsl_lpuart.c | 13 ++++++++++++-
> 1 file changed, 12 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/tty/serial/fsl_lpuart.c b/drivers/tty/serial/fsl_lpuart.c
> index 8918e08bb19e..bb12b328e224 100644
> --- a/drivers/tty/serial/fsl_lpuart.c
> +++ b/drivers/tty/serial/fsl_lpuart.c
> @@ -1682,6 +1682,16 @@ static int lpuart_startup(struct uart_port *port)
> return 0;
> }
>
> +static void lpuart32_hw_disable(struct lpuart_port *sport) {
> + unsigned long temp;
> +
> + temp = lpuart32_read(&sport->port, UARTCTRL);
> + temp &= ~(UARTCTRL_RIE | UARTCTRL_ILIE | UARTCTRL_RE |
> + UARTCTRL_TIE | UARTCTRL_TE);
> + lpuart32_write(&sport->port, temp, UARTCTRL); }
> +
> static void lpuart32_configure(struct lpuart_port *sport) {
> unsigned long temp;
> @@ -1706,11 +1716,12 @@ static void lpuart32_hw_setup(struct
> lpuart_port *sport)
>
> spin_lock_irqsave(&sport->port.lock, flags);
>
> - lpuart32_setup_watermark_enable(sport);
> + lpuart32_hw_disable(sport);
>
> lpuart_rx_dma_startup(sport);
> lpuart_tx_dma_startup(sport);
>
> + lpuart32_setup_watermark_enable(sport);
> lpuart32_configure(sport);
>
> spin_unlock_irqrestore(&sport->port.lock, flags);
> --
> 2.17.1
