Le 16/02/2022 à 01:18, Lino Sanfilippo a écrit :
In uart_set_rs485_config() the serial core already assigns the passed
serial_rs485 struct to the uart port.
So remove the assignment from the drivers rs485_config() function to avoid
redundancy.
Signed-off-by: Lino Sanfilippo <LinoSanfilippo@xxxxxx>
Acked-by: Richard Genoud <richard.genoud@xxxxxxxxx>
---
drivers/tty/serial/atmel_serial.c | 4 +---
1 file changed, 1 insertion(+), 3 deletions(-)
diff --git a/drivers/tty/serial/atmel_serial.c b/drivers/tty/serial/atmel_serial.c
index 2d09a89974a2..2ab589a3d86c 100644
--- a/drivers/tty/serial/atmel_serial.c
+++ b/drivers/tty/serial/atmel_serial.c
@@ -299,11 +299,9 @@ static int atmel_config_rs485(struct uart_port *port,
/* Resetting serial mode to RS232 (0x0) */
mode &= ~ATMEL_US_USMODE;
- port->rs485 = *rs485conf;
-
if (rs485conf->flags & SER_RS485_ENABLED) {
dev_dbg(port->dev, "Setting UART to RS485\n");
- if (port->rs485.flags & SER_RS485_RX_DURING_TX)
+ if (rs485conf->flags & SER_RS485_RX_DURING_TX)
atmel_port->tx_done_mask = ATMEL_US_TXRDY;
else
atmel_port->tx_done_mask = ATMEL_US_TXEMPTY;
Thanks !
