Terminate DMA transaction and clear CR3_DMAT when shutdown is requested,
instead of when remove is requested. If DMA transfer is not stopped in
shutdown ops, driver will fail to start a new DMA transfer after next
startup ops.
Fixes: 3489187204eb ("serial: stm32: adding dma support")
Signed-off-by: Erwan Le Ray <erwan.leray@xxxxxxxxxxx>
Signed-off-by: Valentin Caron <valentin.caron@xxxxxxxxxxx>
---
drivers/tty/serial/stm32-usart.c | 6 +++++-
1 file changed, 5 insertions(+), 1 deletion(-)
diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index 3244e7f6818c..6cfc3bec6749 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -883,6 +883,11 @@ static void stm32_usart_shutdown(struct uart_port *port)
u32 val, isr;
int ret;
+ if (stm32_port->tx_dma_busy) {
+ dmaengine_terminate_async(stm32_port->tx_ch);
+ stm32_usart_clr_bits(port, ofs->cr3, USART_CR3_DMAT);
+ }
+
/* Disable modem control interrupts */
stm32_usart_disable_ms(port);
@@ -1570,7 +1575,6 @@ static int stm32_usart_serial_remove(struct platform_device *pdev)
writel_relaxed(cr3, port->membase + ofs->cr3);
if (stm32_port->tx_ch) {
- dmaengine_terminate_async(stm32_port->tx_ch);
stm32_usart_of_dma_tx_remove(stm32_port, pdev);
dma_release_channel(stm32_port->tx_ch);
}
--
2.17.1
