It's used only as a yes-no variable, so make it a bool and switch the
set values appropriately.
Signed-off-by: Jiri Slaby <jslaby@xxxxxxx>
---
drivers/tty/mxser.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/tty/mxser.c b/drivers/tty/mxser.c
index f907de56e08b..309acf3f1ec3 100644
--- a/drivers/tty/mxser.c
+++ b/drivers/tty/mxser.c
@@ -250,7 +250,7 @@ struct mxser_port {
u8 IER; /* Interrupt Enable Register */
u8 MCR; /* Modem control register */
- unsigned char ldisc_stop_rx;
+ bool ldisc_stop_rx;
struct async_icount icount; /* kernel counters for 4 input interrupts */
unsigned int timeout;
@@ -1341,7 +1341,7 @@ static void mxser_stoprx(struct tty_struct *tty)
{
struct mxser_port *info = tty->driver_data;
- info->ldisc_stop_rx = 1;
+ info->ldisc_stop_rx = true;
if (I_IXOFF(tty)) {
if (info->board->must_hwid) {
info->IER &= ~MOXA_MUST_RECV_ISR;
@@ -1374,7 +1374,7 @@ static void mxser_unthrottle(struct tty_struct *tty)
struct mxser_port *info = tty->driver_data;
/* startrx */
- info->ldisc_stop_rx = 0;
+ info->ldisc_stop_rx = false;
if (I_IXOFF(tty)) {
if (info->x_char)
info->x_char = 0;
@@ -1849,7 +1849,7 @@ static void mxser_initbrd(struct mxser_board *brd, bool high_baud)
tty_port_init(&info->port);
info->port.ops = &mxser_port_ops;
info->board = brd;
- info->ldisc_stop_rx = 0;
+ info->ldisc_stop_rx = false;
/* Enhance mode enabled here */
if (brd->must_hwid != MOXA_OTHER_UART)
--
2.33.0
