The Tegra serial driver always prints an error message when enabling the
FIFO for devices that have support for checking the FIFO enable status.
Fix this by displaying the error message, only when an error occurs.
Finally, update the error message to make it clear that enabling the
FIFO failed and display the error code.
Fixes: 222dcdff3405 ("serial: tegra: check for FIFO mode enabled status")
Cc: <stable@xxxxxxxxxxxxxxx>
Signed-off-by: Jon Hunter <jonathanh@xxxxxxxxxx>
---
Changes since V1:
- Updated the error message to make it more meaningful.
drivers/tty/serial/serial-tegra.c | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)
diff --git a/drivers/tty/serial/serial-tegra.c b/drivers/tty/serial/serial-tegra.c
index 222032792d6c..eba5b9ecba34 100644
--- a/drivers/tty/serial/serial-tegra.c
+++ b/drivers/tty/serial/serial-tegra.c
@@ -1045,9 +1045,11 @@ static int tegra_uart_hw_init(struct tegra_uart_port *tup)
if (tup->cdata->fifo_mode_enable_status) {
ret = tegra_uart_wait_fifo_mode_enabled(tup);
- dev_err(tup->uport.dev, "FIFO mode not enabled\n");
- if (ret < 0)
+ if (ret < 0) {
+ dev_err(tup->uport.dev,
+ "Failed to enable FIFO mode: %d\n", ret);
return ret;
+ }
} else {
/*
* For all tegra devices (up to t210), there is a hardware
--
2.25.1
