Il 02/02/2021 01:02, Eric Tremblay ha scritto:
On 2021-01-28 7:12 p.m., Giulio Benetti wrote:
Hi Eric,
Il giorno 29 gen 2021, alle ore 00:37, Eric Tremblay <etremblay@xxxxxxxxxxxxxxxxxxxx> ha scritto:
The series is mainly about the support of 8250 UART without TEMT
interrupt. I saw that there was some development in the past but
it was never merged. Since the last discussion were quite some
time ago, I was not sure if I should post a v4 over the
last v3 or start from scratch so I decided to post a new patch. Please
advice if I should have done the reverse.
Please keep my and Heiko’s SoB and add your SoB too describing between [ ] what Heiko has done and what you’ve done.
For example:
SoB: Giulio
SoB: Heiko
[Heiko: ...]
SoB Eric
[Eric: improved timeout etc.]
I will add them in the next version, thanks for mentioning it.
Thank you
The approach is a little different from the last proposed patch which was
doing using a polling at 100us. I tought that it could be really long on
some fast baudrate and really not that long on slow baudrate. The current
approach is to calculate the time of a bytes when the settings are changed.
When we get the interrupt for the empty FIFO, it's the longer it can take
to empty the shift register.
Good idea.
The other two patches are to use that features with the PORT_16550A_FSL64
found on some chip like the LS1043A.
Do you mind to add my 8250_dw patch that was originally part of this patchset? I had to send it
soon, you’ve preceded me :-)
I think there was still a comment pending on that patch. I think you should resubmit
since I think it's a bit out-of-scope for me.
Ah yes, you're correct, I will submit it then.
Best regards
--
Giulio Benetti
CTO
MICRONOVA SRL
Sede: Via A. Niedda 3 - 35010 Vigonza (PD)
Tel. 049/8931563 - Fax 049/8931346
Cod.Fiscale - P.IVA 02663420285
Capitale Sociale € 26.000 i.v.
Iscritta al Reg. Imprese di Padova N. 02663420285
Numero R.E.A. 258642
Thank you
Best regards
Giulio
Thanks
Eric Tremblay (3):
serial: 8250: Handle UART without interrupt on TEMT using em485
serial: 8250: add compatible for fsl,16550-FIFO64
serial: 8250: remove UART_CAP_TEMT on PORT_16550A_FSL64
drivers/tty/serial/8250/8250.h | 1 +
drivers/tty/serial/8250/8250_bcm2835aux.c | 2 +-
drivers/tty/serial/8250/8250_of.c | 5 ++
drivers/tty/serial/8250/8250_omap.c | 2 +-
drivers/tty/serial/8250/8250_port.c | 89 ++++++++++++++++++++++-
include/linux/serial_8250.h | 2 +
6 files changed, 98 insertions(+), 3 deletions(-)
--
2.17.1
