From: Douglas Anderson <dianders@xxxxxxxxxxxx>
[ Upstream commit e83766334f96b3396a71c7baa3b0b53dfd5190cd ]
On a board using qcom_geni_serial I found that I could no longer
interact with kdb if I got a crash after the "agetty" running on the
same serial port was killed. This meant that various classes of
crashes that happened at reboot time were undebuggable.
Reading through the code, I couldn't figure out why qcom_geni_serial
felt the need to run so much code at port shutdown time. All we need
to do is disable the interrupt.
After I make this change then a hardcoded kgdb_breakpoint in some late
shutdown code now allows me to interact with the debugger. I also
could freely close / re-open the port without problems.
Fixes: c4f528795d1a ("tty: serial: msm_geni_serial: Add serial driver support for GENI based QUP")
Signed-off-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
Link: https://lore.kernel.org/r/20200313134635.1.Icf54c533065306b02b880c46dfd401d8db34e213@changeid
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
drivers/tty/serial/qcom_geni_serial.c | 6 ------
1 file changed, 6 deletions(-)
diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c
index ebace5ad175ca..7a6fa4ab780f7 100644
--- a/drivers/tty/serial/qcom_geni_serial.c
+++ b/drivers/tty/serial/qcom_geni_serial.c
@@ -846,17 +846,11 @@ static void get_tx_fifo_size(struct qcom_geni_serial_port *port)
static void qcom_geni_serial_shutdown(struct uart_port *uport)
{
- unsigned long flags;
-
/* Stop the console before stopping the current tx */
if (uart_console(uport))
console_stop(uport->cons);
disable_irq(uport->irq);
- spin_lock_irqsave(&uport->lock, flags);
- qcom_geni_serial_stop_tx(uport);
- qcom_geni_serial_stop_rx(uport);
- spin_unlock_irqrestore(&uport->lock, flags);
}
static int qcom_geni_serial_port_setup(struct uart_port *uport)
--
2.20.1
