STM32 F7/H7 usarts supports RX & TX pin swapping.
Add option to turn it on.
Tested on STM32MP157.
Signed-off-by: Martin Devera <devik@xxxxxxxxxx>
---
drivers/tty/serial/stm32-usart.c | 3 ++-
drivers/tty/serial/stm32-usart.h | 1 +
2 files changed, 3 insertions(+), 1 deletion(-)
diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index fdcc2142aa79..8d25869a02eb 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -780,7 +780,7 @@ static void stm32_set_termios(struct uart_port *port, struct ktermios *termios,
cr1 = USART_CR1_TE | USART_CR1_RE;
if (stm32_port->fifoen)
cr1 |= USART_CR1_FIFOEN;
- cr2 = 0;
+ cr2 = stm32_port->swap ? USART_CR2_SWAP : 0;
/* Tx and RX FIFO configuration */
cr3 = readl_relaxed(port->membase + ofs->cr3);
@@ -1097,6 +1097,7 @@ static struct stm32_port *stm32_of_get_stm32_port(struct platform_device *pdev)
stm32_ports[id].hw_flow_control = of_property_read_bool(np,
"st,hw-flow-ctrl");
+ stm32_ports[id].swap = of_property_read_bool(np, "st,swap");
stm32_ports[id].port.line = id;
stm32_ports[id].cr1_irq = USART_CR1_RXNEIE;
stm32_ports[id].cr3_irq = 0;
diff --git a/drivers/tty/serial/stm32-usart.h b/drivers/tty/serial/stm32-usart.h
index 2a68bc48652e..2503a91b890c 100644
--- a/drivers/tty/serial/stm32-usart.h
+++ b/drivers/tty/serial/stm32-usart.h
@@ -275,6 +275,7 @@ struct stm32_port {
enum dma_cb rx_dma_cb; /* dma rx callback status */
bool tx_dma_busy; /* dma tx busy */
bool hw_flow_control;
+ bool swap; /* swap RX & TX pins */
bool fifoen;
int wakeirq;
struct pinctrl_state *console_pins;
--
2.11.0
