Re: [PATCH V3] tty: serial: qcom_geni_serial: Support pin swapping

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, Feb 28, 2020 at 06:18:10PM +0530, Roja Rani Yarubandi wrote:
> Add capability to supoort RX-TX, CTS-RTS pins swap in HW.
> 
> Configure UART_IO_MACRO_CTRL register accordingly if RX-TX pair
> or CTS-RTS pair or both pairs swapped.
> 
> Signed-off-by: Roja Rani Yarubandi <rojay@xxxxxxxxxxxxxx>
> ---
> Changes in V2:
> - As per Greg's comment removed the change id.
> 
> Changes in V3:
> - As per Bjorn's comment using of_property_read_bool() to read dtsi entries.
> - As per Matthias's comment add capability to support individual pairs swap,
>   that is, only RX-TX swap and only CTS-RTS swap cases.
> 
> Dt-bindings support for this is posted at
> https://patchwork.kernel.org/patch/11385969/
> 
>  drivers/tty/serial/qcom_geni_serial.c | 30 +++++++++++++++++++++++++++
>  1 file changed, 30 insertions(+)
> 
> diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c
> index 191abb18fc2a..2ad041cde4d7 100644
> --- a/drivers/tty/serial/qcom_geni_serial.c
> +++ b/drivers/tty/serial/qcom_geni_serial.c
> @@ -21,6 +21,7 @@
>  
>  /* UART specific GENI registers */
>  #define SE_UART_LOOPBACK_CFG		0x22c
> +#define SE_UART_IO_MACRO_CTRL		0x240
>  #define SE_UART_TX_TRANS_CFG		0x25c
>  #define SE_UART_TX_WORD_LEN		0x268
>  #define SE_UART_TX_STOP_BIT_LEN		0x26c
> @@ -95,6 +96,12 @@
>  #define CTS_RTS_SORTED	BIT(1)
>  #define RX_TX_CTS_RTS_SORTED	(RX_TX_SORTED | CTS_RTS_SORTED)
>  
> +/* UART pin swap value */
> +#define DEFAULT_IO_MACRO_IO0_IO1_MASK		GENMASK(3, 0)
> +#define IO_MACRO_IO0_SEL		GENMASK(1, 0)

not sure the use of GENMASK adds value here since it's not a mask, I
rather find it obfuscating, IMO just 0x03 / 0x3 would be clearer.

> +#define DEFAULT_IO_MACRO_IO2_IO3_MASK		GENMASK(15, 4)
> +#define IO_MACRO_IO2_IO3_SWAP		0x4640
> +
>  #ifdef CONFIG_CONSOLE_POLL
>  #define CONSOLE_RX_BYTES_PW 1
>  #else
> @@ -119,6 +126,8 @@ struct qcom_geni_serial_port {
>  
>  	unsigned int tx_remaining;
>  	int wakeup_irq;
> +	bool rx_tx_swap;
> +	bool cts_rts_swap;
>  };
>  
>  static const struct uart_ops qcom_geni_console_pops;
> @@ -826,6 +835,7 @@ static int qcom_geni_serial_port_setup(struct uart_port *uport)
>  	struct qcom_geni_serial_port *port = to_dev_port(uport, uport);
>  	u32 rxstale = DEFAULT_BITS_PER_CHAR * STALE_TIMEOUT;
>  	u32 proto;
> +	u32 pin_swap;
>  
>  	if (uart_console(uport)) {
>  		port->tx_bytes_pw = 1;
> @@ -846,6 +856,20 @@ static int qcom_geni_serial_port_setup(struct uart_port *uport)
>  	get_tx_fifo_size(port);
>  
>  	writel(rxstale, uport->membase + SE_UART_RX_STALE_CNT);
> +
> +	pin_swap = readl(uport->membase + SE_UART_IO_MACRO_CTRL);
> +	if (port->rx_tx_swap) {
> +		pin_swap &= ~DEFAULT_IO_MACRO_IO2_IO3_MASK;
> +		pin_swap |= IO_MACRO_IO2_IO3_SWAP;
> +	}
> +	if (port->cts_rts_swap) {
> +		pin_swap &= ~DEFAULT_IO_MACRO_IO0_IO1_MASK;
> +		pin_swap |= IO_MACRO_IO0_SEL;
> +	}
> +	/* Configure this register if RX-TX, CTS-RTS pins are swapped */
> +	if (port->rx_tx_swap || port->cts_rts_swap)
> +		writel(pin_swap, uport->membase + SE_UART_IO_MACRO_CTRL);
> +
>  	/*
>  	 * Make an unconditional cancel on the main sequencer to reset
>  	 * it else we could end up in data loss scenarios.
> @@ -1289,6 +1313,12 @@ static int qcom_geni_serial_probe(struct platform_device *pdev)
>  	if (!console)
>  		port->wakeup_irq = platform_get_irq_optional(pdev, 1);
>  
> +	if (of_property_read_bool(pdev->dev.of_node, "rx-tx-swap"))
> +		port->rx_tx_swap = true;
> +
> +	if (of_property_read_bool(pdev->dev.of_node, "cts-rts-swap"))
> +		port->cts_rts_swap = true;
> +
>  	uport->private_data = drv;
>  	platform_set_drvdata(pdev, port);
>  	port->handle_rx = console ? handle_rx_console : handle_rx_uart;

Tested-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
(TX/RX swap)



[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux PPP]     [Linux FS]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Linmodem]     [Device Mapper]     [Linux Kernel for ARM]

  Powered by Linux