[PATCH v2 1/2] dt-bindings: serial: document fsl,inverted-tx and -rx options

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Add a description for the new fsl,inverted-tx and fsl,inverted-rx
options for the i.MX UART peripheral.

Signed-off-by: George Hilliard <ghilliard@xxxxxxxxxxxxxxx>
---
v1..v2: Removed confidentiality spam

 Documentation/devicetree/bindings/serial/fsl-imx-uart.txt | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt b/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
index 35957cbf1571..c8d677f9491f 100644
--- a/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
+++ b/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
@@ -8,6 +8,10 @@ Required properties:
 Optional properties:
 - fsl,dte-mode : Indicate the uart works in DTE mode. The uart works
                   in DCE mode by default.
+- fsl,inverted-tx , fsl,inverted-rx : Indicate that the hardware attached
+  to the peripheral inverts the signal transmitted or received,
+  respectively, and that the peripheral should invert its output/input
+  using the INVT/INVR registers.
 - rs485-rts-delay, rs485-rts-active-low, rs485-rx-during-tx,
   linux,rs485-enabled-at-boot-time: see rs485.txt. Note that for RS485
   you must enable either the "uart-has-rtscts" or the "rts-gpios"
-- 
2.25.0




[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux PPP]     [Linux FS]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Linmodem]     [Device Mapper]     [Linux Kernel for ARM]

  Powered by Linux