UART port might be pre-configured with rs485 enabled flag at the
time of the port starting up process. In this case we need to
have the hardware rs485-related registers initialized in accordance
with the rs485 flags and settings provided by the configs descriptor.
Signed-off-by: Serge Semin <fancer.lancer@xxxxxxxxx>
---
drivers/tty/serial/max310x.c | 16 ++++++++++++++++
1 file changed, 16 insertions(+)
diff --git a/drivers/tty/serial/max310x.c b/drivers/tty/serial/max310x.c
index 2255300404bd..36943f6c198c 100644
--- a/drivers/tty/serial/max310x.c
+++ b/drivers/tty/serial/max310x.c
@@ -1030,6 +1030,22 @@ static int max310x_startup(struct uart_port *port)
max310x_port_update(port, MAX310X_MODE2_REG,
MAX310X_MODE2_FIFORST_BIT, 0);
+ /* Configure mode1/mode2 to have rs485/rs232 enabled at startup */
+ val = (clamp(port->rs485.delay_rts_before_send, 0U, 15U) << 4) |
+ clamp(port->rs485.delay_rts_after_send, 0U, 15U);
+ max310x_port_write(port, MAX310X_HDPIXDELAY_REG, val);
+
+ if (port->rs485.flags & SER_RS485_ENABLED) {
+ max310x_port_update(port, MAX310X_MODE1_REG,
+ MAX310X_MODE1_TRNSCVCTRL_BIT,
+ MAX310X_MODE1_TRNSCVCTRL_BIT);
+
+ if (!(port->rs485.flags & SER_RS485_RX_DURING_TX))
+ max310x_port_update(port, MAX310X_MODE2_REG,
+ MAX310X_MODE2_ECHOSUPR_BIT,
+ MAX310X_MODE2_ECHOSUPR_BIT);
+ }
+
/* Configure flow control levels */
/* Flow control halt level 96, resume level 48 */
max310x_port_write(port, MAX310X_FLOWLVL_REG,
--
2.21.0
