[PATCH] serial: sh-sci: Fix HSCIF RX sampling point calculation

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



There are several issues with the formula used for calculating the
deviation from the intended rate:
  1. While min_err and last_stop are signed, srr and baud are unsigned.
     Hence the signed values are promoted to unsigned, which will lead
     to a bogus value of deviation if min_err is negative,
  2. Srr is the register field value, which is one less than the actual
     sampling rate factor,
  3. The divisions do not use rounding.

Fix this by casting unsigned variables to int, adding one to srr, and
using a single DIV_ROUND_CLOSEST().

Fixes: 63ba1e00f178a448 ("serial: sh-sci: Support for HSCIF RX sampling point adjustment")
Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
---
Anyone with a good test setup for verifying this feature actually works
as advertised?
---
 drivers/tty/serial/sh-sci.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/drivers/tty/serial/sh-sci.c b/drivers/tty/serial/sh-sci.c
index 2bdaeba5d527a6ce..8dea59edde34c224 100644
--- a/drivers/tty/serial/sh-sci.c
+++ b/drivers/tty/serial/sh-sci.c
@@ -2522,7 +2522,9 @@ static void sci_set_termios(struct uart_port *port, struct ktermios *termios,
 			 * center of the last stop bit in sampling clocks.
 			 */
 			int last_stop = bits * 2 - 1;
-			int deviation = min_err * srr * last_stop / 2 / baud;
+			int deviation = DIV_ROUND_CLOSEST(min_err * last_stop *
+							  (int)(srr + 1),
+							  2 * (int)baud);
 
 			if (abs(deviation) >= 2) {
 				/* At least two sampling clocks off at the
-- 
2.17.1




[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux PPP]     [Linux FS]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Linmodem]     [Device Mapper]     [Linux Kernel for ARM]

  Powered by Linux