[PATCH] serial: samsung: Enable baud clock for UART reset procedure in resume

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Ensure that the baud clock is also enabled for UART register writes in
driver resume. On Exynos5433 SoC this is needed to avoid external abort
issue.

Signed-off-by: Marek Szyprowski <m.szyprowski@xxxxxxxxxxx>
---
 drivers/tty/serial/samsung.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/tty/serial/samsung.c b/drivers/tty/serial/samsung.c
index 2f8fa184aafa..da1bd4bba8a9 100644
--- a/drivers/tty/serial/samsung.c
+++ b/drivers/tty/serial/samsung.c
@@ -1941,7 +1941,11 @@ static int s3c24xx_serial_resume(struct device *dev)
 
 	if (port) {
 		clk_prepare_enable(ourport->clk);
+		if (!IS_ERR(ourport->baudclk))
+			clk_prepare_enable(ourport->baudclk);
 		s3c24xx_serial_resetport(port, s3c24xx_port_to_cfg(port));
+		if (!IS_ERR(ourport->baudclk))
+			clk_disable_unprepare(ourport->baudclk);
 		clk_disable_unprepare(ourport->clk);
 
 		uart_resume_port(&s3c24xx_uart_drv, port);
@@ -1964,7 +1968,11 @@ static int s3c24xx_serial_resume_noirq(struct device *dev)
 			if (rx_enabled(port))
 				uintm &= ~S3C64XX_UINTM_RXD_MSK;
 			clk_prepare_enable(ourport->clk);
+			if (!IS_ERR(ourport->baudclk))
+				clk_prepare_enable(ourport->baudclk);
 			wr_regl(port, S3C64XX_UINTM, uintm);
+			if (!IS_ERR(ourport->baudclk))
+				clk_disable_unprepare(ourport->baudclk);
 			clk_disable_unprepare(ourport->clk);
 		}
 	}
-- 
2.17.1




[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux PPP]     [Linux FS]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Linmodem]     [Device Mapper]     [Linux Kernel for ARM]

  Powered by Linux