Exar UARTs by default supports only up to 8 channels,
all above go as extension. Thus, there is no need to have
an additional property to distinguish them from first ones.
Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
---
drivers/tty/serial/8250/8250_exar.c | 7 ++-----
1 file changed, 2 insertions(+), 5 deletions(-)
diff --git a/drivers/tty/serial/8250/8250_exar.c b/drivers/tty/serial/8250/8250_exar.c
index 2ae4fc4f657c..733dbf8d0fee 100644
--- a/drivers/tty/serial/8250/8250_exar.c
+++ b/drivers/tty/serial/8250/8250_exar.c
@@ -115,7 +115,6 @@ struct exar8250_platform {
struct exar8250_board {
unsigned int num_ports;
unsigned int reg_shift;
- bool has_slave;
int (*setup)(struct exar8250 *, struct pci_dev *,
struct uart_8250_port *, int);
void (*exit)(struct pci_dev *pcidev);
@@ -474,10 +473,10 @@ pci_xr17v35x_setup(struct exar8250 *priv, struct pci_dev *pcidev,
port->port.rs485_config = platform->rs485_config;
/*
- * Setup the uart clock for the devices on expansion slot to
+ * Setup the UART clock for the devices on expansion slot to
* half the clock speed of the main chip (which is 125MHz)
*/
- if (board->has_slave && idx >= 8)
+ if (idx >= 8)
port->port.uartclk /= 2;
ret = default_setup(priv, pcidev, idx, offset, port);
@@ -655,14 +654,12 @@ static const struct exar8250_board pbn_exar_XR17V35x = {
static const struct exar8250_board pbn_exar_XR17V4358 = {
.num_ports = 12,
- .has_slave = true,
.setup = pci_xr17v35x_setup,
.exit = pci_xr17v35x_exit,
};
static const struct exar8250_board pbn_exar_XR17V8358 = {
.num_ports = 16,
- .has_slave = true,
.setup = pci_xr17v35x_setup,
.exit = pci_xr17v35x_exit,
};
--
2.18.0
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
