Add struct uartlite_data, to store the private data of the Uartlite driver. Signed-off-by: Tanvi Desai <tanvi.desai@xxxxxxxxxx> Signed-off-by: Shubhrajyoti Datta <shubhrajyoti.datta@xxxxxxxxxx> --- drivers/tty/serial/uartlite.c | 29 +++++++++++++++++++++-------- 1 file changed, 21 insertions(+), 8 deletions(-) diff --git a/drivers/tty/serial/uartlite.c b/drivers/tty/serial/uartlite.c index c47db78..0f798f7 100644 --- a/drivers/tty/serial/uartlite.c +++ b/drivers/tty/serial/uartlite.c @@ -54,6 +54,10 @@ #define ULITE_CONTROL_RST_RX 0x02 #define ULITE_CONTROL_IE 0x10 +struct uartlite_data { + const struct uartlite_reg_ops *reg_ops; +}; + struct uartlite_reg_ops { u32 (*in)(void __iomem *addr); void (*out)(u32 val, void __iomem *addr); @@ -91,16 +95,16 @@ static const struct uartlite_reg_ops uartlite_le = { static inline u32 uart_in32(u32 offset, struct uart_port *port) { - const struct uartlite_reg_ops *reg_ops = port->private_data; + struct uartlite_data *pdata = port->private_data; - return reg_ops->in(port->membase + offset); + return pdata->reg_ops->in(port->membase + offset); } static inline void uart_out32(u32 val, u32 offset, struct uart_port *port) { - const struct uartlite_reg_ops *reg_ops = port->private_data; + struct uartlite_data *pdata = port->private_data; - reg_ops->out(val, port->membase + offset); + pdata->reg_ops->out(val, port->membase + offset); } static struct uart_port ulite_ports[ULITE_NR_UARTS]; @@ -325,6 +329,7 @@ static void ulite_release_port(struct uart_port *port) static int ulite_request_port(struct uart_port *port) { + struct uartlite_data *pdata = port->private_data; int ret; pr_debug("ulite console: port=%p; port->mapbase=%llx\n", @@ -342,13 +347,13 @@ static int ulite_request_port(struct uart_port *port) return -EBUSY; } - port->private_data = (void *)&uartlite_be; + pdata->reg_ops = &uartlite_be; ret = uart_in32(ULITE_CONTROL, port); uart_out32(ULITE_CONTROL_RST_TX, ULITE_CONTROL, port); ret = uart_in32(ULITE_STATUS, port); /* Endianess detection */ if ((ret & ULITE_STATUS_TXEMPTY) != ULITE_STATUS_TXEMPTY) - port->private_data = (void *)&uartlite_le; + pdata->reg_ops = &uartlite_le; return 0; } @@ -585,10 +590,12 @@ static struct uart_driver ulite_uart_driver = { * @id: requested id number. Pass -1 for automatic port assignment * @base: base address of uartlite registers * @irq: irq number for uartlite + * @pdata: private data for uartlite * * Returns: 0 on success, <0 otherwise */ -static int ulite_assign(struct device *dev, int id, u32 base, int irq) +static int ulite_assign(struct device *dev, int id, u32 base, int irq, + struct uartlite_data *pdata) { struct uart_port *port; int rc; @@ -625,6 +632,7 @@ static int ulite_assign(struct device *dev, int id, u32 base, int irq) port->dev = dev; port->type = PORT_UNKNOWN; port->line = id; + port->private_data = pdata; dev_set_drvdata(dev, port); @@ -675,6 +683,7 @@ MODULE_DEVICE_TABLE(of, ulite_of_match); static int ulite_probe(struct platform_device *pdev) { struct resource *res; + struct uartlite_data *pdata; int irq; int id = pdev->id; #ifdef CONFIG_OF @@ -684,6 +693,10 @@ static int ulite_probe(struct platform_device *pdev) if (prop) id = be32_to_cpup(prop); #endif + pdata = devm_kzalloc(&pdev->dev, sizeof(struct uartlite_data), + GFP_KERNEL); + if (!pdata) + return -ENOMEM; res = platform_get_resource(pdev, IORESOURCE_MEM, 0); if (!res) @@ -693,7 +706,7 @@ static int ulite_probe(struct platform_device *pdev) if (irq <= 0) return -ENXIO; - return ulite_assign(&pdev->dev, id, res->start, irq); + return ulite_assign(&pdev->dev, id, res->start, irq, pdata); } static int ulite_remove(struct platform_device *pdev) -- 2.7.4 This email and any attachments are intended for the sole use of the named recipient(s) and contain(s) confidential information that may be proprietary, privileged or copyrighted under applicable law. If you are not the intended recipient, do not read, copy, or forward this email message or any attachments. Delete this email message and any attachments immediately. -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html