On Wed 31 Jan 10:58 PST 2018, Karthik Ramasubramanian wrote: > On 1/16/2018 11:20 PM, Bjorn Andersson wrote: > > On Fri 12 Jan 17:05 PST 2018, Karthikeyan Ramasubramanian wrote: [..] > > I'm not aware of any non-serial-engine "geni" at Qualcomm, so can we > > drop the "se" throughout this driver? > Currently GENI is used to program just the serial engines. But it is not > restricted to that. It can be used to program other hardware cores. Hence > keeping "se" will help to clarify that this driver is meant for GENI based > serial engines only. Okay, fair enough. [..] > > > diff --git a/drivers/soc/qcom/qcom-geni-se.c b/drivers/soc/qcom/qcom-geni-se.c [..] > > > + geni_cgc_ctrl = geni_read_reg(base, GENI_CGC_CTRL); > > > + dma_general_cfg = geni_read_reg(base, SE_DMA_GENERAL_CFG); > > > + geni_cgc_ctrl |= DEFAULT_CGC_EN; > > > + dma_general_cfg |= (AHB_SEC_SLV_CLK_CGC_ON | DMA_AHB_SLV_CFG_ON | > > > + DMA_TX_CLK_CGC_ON | DMA_RX_CLK_CGC_ON); > > > > Drop the parenthesis and there's no harm in making multiple assignments > > in favour of splitting the line. > Ok. > > > > > + io_op_ctrl = DEFAULT_IO_OUTPUT_CTRL_MSK; > > > + geni_write_reg(geni_cgc_ctrl, base, GENI_CGC_CTRL); > > > + geni_write_reg(dma_general_cfg, base, SE_DMA_GENERAL_CFG); > > > > Is there a reason why this chunk of code is a mix of 3 independent > > register updates? > I am not sure I understand the context of your question. This is how the > hardware programming manual is describing to program the registers as part > of initializing a serial engine. Please let me know if this is not the > information you are looking for. Can you please double check with the hardware guys if it really is required that you do: a = read(A) b = read(B) modify a modify b assign c write(a) write(b) write(c) And if that is the case, then try to make things as easy to read as possible - e.g. by inlining the value of "c" and adding an empty line between reads, modifications and writes as I did here. Regards, Bjorn -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
