Add a node in Armada 37xx DTSI file for the second UART, with a different compatible due to its extended IP which has some differences with the first UART already in place. Make use of this commit to also fully describe the first port and use the same clear and named interrupt bindings for both ports. The standard UART (UART0) uses level-interrupts while the extended UART (UART1) uses edge-triggered interrupts. Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxxxxxxxxx> --- arch/arm64/boot/dts/marvell/armada-37xx.dtsi | 18 +++++++++++++++++- 1 file changed, 17 insertions(+), 1 deletion(-) diff --git a/arch/arm64/boot/dts/marvell/armada-37xx.dtsi b/arch/arm64/boot/dts/marvell/armada-37xx.dtsi index a36d667f770e..72b68f23c001 100644 --- a/arch/arm64/boot/dts/marvell/armada-37xx.dtsi +++ b/arch/arm64/boot/dts/marvell/armada-37xx.dtsi @@ -55,6 +55,7 @@ aliases { serial0 = &uart0; + serial1 = &uart1; }; cpus { @@ -136,7 +137,22 @@ compatible = "marvell,armada-3700-uart"; reg = <0x12000 0x200>; clocks = <&xtalclk>; - interrupts = <GIC_SPI 11 IRQ_TYPE_LEVEL_HIGH>; + interrupts = + <GIC_SPI 11 IRQ_TYPE_LEVEL_HIGH>, + <GIC_SPI 12 IRQ_TYPE_LEVEL_HIGH>, + <GIC_SPI 13 IRQ_TYPE_LEVEL_HIGH>; + interrupt-names = "uart-sum", "uart-tx", "uart-rx"; + status = "disabled"; + }; + + uart1: serial@12200 { + compatible = "marvell,armada-3700-uart-ext"; + reg = <0x12200 0x30>; + clocks = <&xtalclk>; + interrupts = + <GIC_SPI 30 IRQ_TYPE_EDGE_RISING>, + <GIC_SPI 31 IRQ_TYPE_EDGE_RISING>; + interrupt-names = "uart-tx", "uart-rx"; status = "disabled"; }; -- 2.11.0 -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html