Hi Geert,
> Which port are you using? SCIF or HSCIF?
just SCIF
> You mean sci_set_mctrl() isn't called by the serial core after
> sci_set_termios()?
>
> However, uart_set_termios() calls both uart_change_speed() and
> uart_{clear,set}_mctrl(), in that order?
Upon calling open() on the tty device sci_set_termios() and sci_set_mctrl() are called in this order.
When issuing changes (baud rate, CRTSCTS...) only sci_set_termios() gets called.
On calling close() sci_set_mctrl() and sci_shutdown() are called in this order.
> Have you tried using GPIO RTS/CTS instead of hardware-assisted
> RTS/CTS?
> Does it show the same behavior?
> When adding support for hardware-assisted RTS/CTS, I used the
> behavior of GPIO RTS/CTS as the expected behavior.
No, I haven't tried GPIO RTS/CTS so far. How would this be configured?
Regards,
Christoph
��.n��������+%������w��{.n�����{��ǫ����{ay� ʇڙ���f���h������_�(�階�ݢj"��������G����?���&��
