On 2016/8/10 0:01, Andy Shevchenko wrote: > On Fri, 2016-07-15 at 19:01 +0800, Kefeng Wang wrote: >> Make dw8250_set_termios() as the default set_termios callback for 8250 >> dw uart, correct me >> if I am wrong. >> >> Then add ACPI support for uart on Hisilicon Hip05 soc, be careful that >> it is not 16500 >> compatible. Meanwhile, set dw8250_serial_out32 to keep consistent >> between serial_out >> and serial_in in ACPI. > > I will review it perhaps late this week. Thanks. > Though have a quick question, did you test it? I hope you have done. Yes, I have already tested the patchset on D02 board. Kefeng > >> >> Change since v2: >> - Add a new patch to use new var dev in probe >> - Use built-in device properties to set device parameters for existing >> device probed by acpi, >> suggested by Andy Shevchenko >> >> >> Change since v1: >> - Use acpi_match_device() instead of acpi_dev_found(), limit the check >> to the device >> being probed and not a global search for whole DSDT (pointed by grae >> me.gregory@xxxxxxxxxx) >> >> Kefeng Wang (3): >> serial: 8250_dw: make dw8250_set_termios as default set_termios >> callback >> serial: 8250_dw: Use new dev variable in probe >> serial: 8250_dw: add ACPI support for uart on Hisilicon Hip05 soc >> >> drivers/tty/serial/8250/8250_dw.c | 71 ++++++++++++++++++++++------ >> ----------- >> 1 file changed, 41 insertions(+), 30 deletions(-) >> > -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
