Re: [PATCH v1 12/12] serial: 8250_lpss: enable DMA on Intel Quark UART

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, 2016-04-13 at 17:48 +0300, Andy Shevchenko wrote:
> Wait, you mean flow control between DMA controller and UART FIFO, or
> I
> misread you?

Yup.

It's a while since I read the spec and talked to the relevant people
but... I have this memory that the FIFO fill signal and DMA block were
'wired up' @ the AHB level. That would be how the UART and DMA block
would flow-control each other for descriptor chaining at any rate and
so one assumes that its active at the block-to-fifo layer.

Meh I don't have the UART EAS anymore to comment in detail.. 

I think the right thing to do is to be safe (so I'll ACK your series)
and then run an experiment to push the burst size upwards. If you have
the EAS handy though it might be worthwhile working out when the DMA
block will flow-control w/r to the FIFO fill level - I *think* (but
can't prove since I don't have the EAS anymore) that it's safe to push
that value higher.

---
bod
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux PPP]     [Linux FS]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Linmodem]     [Device Mapper]     [Linux Kernel for ARM]

  Powered by Linux