On Wed, 2016-04-13 at 12:22 +0100, Bryan O'Donoghue wrote:
> On Tue, 2016-04-12 at 19:50 +0300, Andy Shevchenko wrote:
> >
> > >
> > > I haven't read your V2 yet but on this, I'd suggest raising the
> > burst
> > >
> > > size to 32 bytes for UART (no higher) we found during bringup that
> > > larger sizes "fall-over and die" but, anything up to 32 bytes is
> > > OK
> > -
> > >
> > > and therefore you should be able to reduce the number of
> > > bursts/interrupts etc.
> > It can't be more that FIFO size and recommendation as far as I know
> > is
> > FIFO/2, which is exactly 8 bytes.
> Why not ?
Because a probability of FIFO overrun.
There is a big chapter ("Peripheral Burst Transaction Requests") in
dw_apb_dmac_db.pdf covering this.
>
> We went as high as 32 bytes previously in the BSP with no obvious
> errors.
>
> At 8 bytes or 1/2 of the FIFO size I'd ask the question is DMA even
> worth it i.e. does it take more time to setup and execute a DMA
> transaction @ 1/2 FIFO size than just writing straight into the FIFO ?
--
Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
Intel Finland Oy
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
