Don't activate the TX Space available IRQ on startup, or a simple $ cat /dev/ttyHSU0 will cause an endless amount of IRQs, as there is always space in the TX FIFO available if no data is going to be sent. Also correct comments for IRQ names (RX and TX swapped). Signed-off-by: Johannes Thumshirn <johannes.thumshirn@xxxxxx> --- drivers/tty/serial/men_z135_uart.c | 7 ++++--- 1 file changed, 4 insertions(+), 3 deletions(-) diff --git a/drivers/tty/serial/men_z135_uart.c b/drivers/tty/serial/men_z135_uart.c index d08eb5d..c9d1854 100644 --- a/drivers/tty/serial/men_z135_uart.c +++ b/drivers/tty/serial/men_z135_uart.c @@ -41,8 +41,8 @@ #define IS_IRQ(x) ((x) & 1) #define IRQ_ID(x) (((x) >> 1) & 7) -#define MEN_Z135_IER_RXCIEN BIT(0) /* TX Space IRQ */ -#define MEN_Z135_IER_TXCIEN BIT(1) /* RX Space IRQ */ +#define MEN_Z135_IER_RXCIEN BIT(0) /* RX Space IRQ */ +#define MEN_Z135_IER_TXCIEN BIT(1) /* TX Space IRQ */ #define MEN_Z135_IER_RLSIEN BIT(2) /* Receiver Line Status IRQ */ #define MEN_Z135_IER_MSIEN BIT(3) /* Modem Status IRQ */ #define MEN_Z135_ALL_IRQS (MEN_Z135_IER_RXCIEN \ @@ -576,7 +576,8 @@ static int men_z135_startup(struct uart_port *port) conf_reg = ioread32(port->membase + MEN_Z135_CONF_REG); - conf_reg |= MEN_Z135_ALL_IRQS; + /* Activate all but TX space available IRQ */ + conf_reg |= MEN_Z135_ALL_IRQS & ~MEN_Z135_IER_TXCIEN; conf_reg &= ~(0xff << 16); conf_reg |= (txlvl << 16); conf_reg |= (rxlvl << 20); -- 1.9.2 -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
