In pl011_rx_chars() if pl011_dma_rx_trigger_dma() succeeds it will disable
the receive interrupt, no need to do this again.
Signed-off-by: Guennadi Liakhovetski <g.liakhovetski@xxxxxx>
---
drivers/tty/serial/amba-pl011.c | 4 +---
1 files changed, 1 insertions(+), 3 deletions(-)
diff --git a/drivers/tty/serial/amba-pl011.c b/drivers/tty/serial/amba-pl011.c
index baecdfa..0efa9d5 100644
--- a/drivers/tty/serial/amba-pl011.c
+++ b/drivers/tty/serial/amba-pl011.c
@@ -1213,8 +1213,8 @@ __acquires(&uap->port.lock)
dev_dbg(uap->port.dev, "could not trigger RX DMA job "
"fall back to interrupt mode again\n");
uap->im |= UART011_RXIM;
+ writew(uap->im, uap->port.membase + UART011_IMSC);
} else {
- uap->im &= ~UART011_RXIM;
#ifdef CONFIG_DMA_ENGINE
/* Start Rx DMA poll */
if (uap->dmarx.poll_rate) {
@@ -1226,8 +1226,6 @@ __acquires(&uap->port.lock)
}
#endif
}
-
- writew(uap->im, uap->port.membase + UART011_IMSC);
}
spin_lock(&uap->port.lock);
}
--
1.7.2.5
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
