Exynos5420 is new SoC in Samsung's Exynos5 SoC series. This series adds
initial support for this SoC.
Changes since v3:
1. Updated the max cpu clock frequency in dt node.
2. Sorted DT nodes alphabetically as suggested by Kukjin.
3. Removed the duplicate commit log comment in:
"clocksource: exynos_mct: use (request/free)_irq calls for local timer
registration"
4. Added comment for Exynos5440 in commit log of the patch:
"ARM: dts: fork out common Exynos5 nodes"
Changes since v2:
1. Renamed oscclk to fin_pll, in order to keep it consistent with
Exynos4/Exynos5
2. Pass memory as single bank rather than splitting in 256MB size banks.
Changes since v1:
1. As not-dt platforms will not be supported from 3.11 onwards, following
patches from previous patch series are dropped:
"irqchip: exynos-combiner: set irq base as 256 for Exynos5420"
"ARM: Exynos: initialize l2x0 cache controller only for cortex-a9 based SoCs"
2. Added device type property in cpu node in the following patch:
"ARM: dts: list the CPU nodes for Exynos5250
3. Sorted out the nodes listed in based upon the physical addresses as suggested
by Tomasz Figa.
4. As Tomasz is going to consolidate the secondary cpu power register address
calculation in all possible scnarios, hence dropped the following patch:
"ARM: Exynos: fix secondary cpu power control register address calculation"
5. Replaced the setup/remove)_irq calls with (request/free)_irq calls as
suggested by Mark Rutland in patch:
"clocksource: exynos_mct: use (request/free)_irq calls for local timer
registration"
6. Changed the registration of epll and rpll from pll35xx to pl36xx.
7. Changed driver data selection for serial port, based on ARCH_EXYNOS.
8. Changed the interrupt cells from 2 to 1 as suggested by Tomasz Figa.
Chander Kashyap (10):
ARM: dts: fork out common Exynos5 nodes
ARM: dts: list the CPU nodes for Exynos5250
ARM: Exynos: Add support for Exynos5420 SoC
serial: samsung: select Exynos specific driver data if ARCH_EXYNOS is
defined
ARM: Exynos: use four additional chipid bits to identify Exynos
family
clk: exynos5420: register clocks using common clock framework
ARM: dts: Add initial device tree support for Exynos5420
clocksource: exynos_mct: use (request/free)_irq calls for local timer
registration
ARM: Exynos: add secondary CPU boot base location for Exynos5420
ARM: Exynos: extend soft-reset support for Exynos5420
.../devicetree/bindings/clock/exynos5420-clock.txt | 201 ++++++
arch/arm/boot/dts/Makefile | 1 +
arch/arm/boot/dts/exynos5.dtsi | 111 +++
arch/arm/boot/dts/exynos5250.dtsi | 78 +-
arch/arm/boot/dts/exynos5420-smdk5420.dts | 33 +
arch/arm/boot/dts/exynos5420.dtsi | 103 +++
arch/arm/mach-exynos/Kconfig | 10 +
arch/arm/mach-exynos/common.c | 18 +-
arch/arm/mach-exynos/include/mach/uncompress.h | 7 +-
arch/arm/mach-exynos/mach-exynos5-dt.c | 1 +
arch/arm/mach-exynos/platsmp.c | 12 +-
arch/arm/plat-samsung/include/plat/cpu.h | 8 +
drivers/clk/samsung/Makefile | 1 +
drivers/clk/samsung/clk-exynos5420.c | 762 ++++++++++++++++++++
drivers/clocksource/exynos_mct.c | 35 +-
drivers/tty/serial/samsung.c | 4 +-
16 files changed, 1279 insertions(+), 106 deletions(-)
create mode 100644 Documentation/devicetree/bindings/clock/exynos5420-clock.txt
create mode 100644 arch/arm/boot/dts/exynos5.dtsi
create mode 100644 arch/arm/boot/dts/exynos5420-smdk5420.dts
create mode 100644 arch/arm/boot/dts/exynos5420.dtsi
create mode 100644 drivers/clk/samsung/clk-exynos5420.c
--
1.7.9.5
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
