From: Sonic Zhang <sonic.zhang@xxxxxxxxxx>
For UARTs that have dedicated hardware flow control support, there will be
no gpios to request/free as they are part of the normal peripheral pins.
Signed-off-by: Sonic Zhang <sonic.zhang@xxxxxxxxxx>
Signed-off-by: Mike Frysinger <vapier@xxxxxxxxxx>
---
drivers/serial/bfin_5xx.c | 16 +---------------
1 files changed, 1 insertions(+), 15 deletions(-)
diff --git a/drivers/serial/bfin_5xx.c b/drivers/serial/bfin_5xx.c
index 50abb7e..15843cc 100644
--- a/drivers/serial/bfin_5xx.c
+++ b/drivers/serial/bfin_5xx.c
@@ -746,15 +746,6 @@ static int bfin_serial_startup(struct uart_port *port)
Status interrupt.\n");
}
- if (uart->cts_pin >= 0) {
- gpio_request(uart->cts_pin, DRIVER_NAME);
- gpio_direction_output(uart->cts_pin, 1);
- }
- if (uart->rts_pin >= 0) {
- gpio_request(uart->rts_pin, DRIVER_NAME);
- gpio_direction_output(uart->rts_pin, 0);
- }
-
/* CTS RTS PINs are negative assertive. */
UART_PUT_MCR(uart, ACTS);
UART_SET_IER(uart, EDSSI);
@@ -801,10 +792,6 @@ static void bfin_serial_shutdown(struct uart_port *port)
gpio_free(uart->rts_pin);
#endif
#ifdef CONFIG_SERIAL_BFIN_HARD_CTSRTS
- if (uart->cts_pin >= 0)
- gpio_free(uart->cts_pin);
- if (uart->rts_pin >= 0)
- gpio_free(uart->rts_pin);
if (UART_GET_IER(uart) && EDSSI)
free_irq(uart->status_irq, uart);
#endif
@@ -1409,8 +1396,7 @@ static int bfin_serial_remove(struct platform_device *dev)
continue;
uart_remove_one_port(&bfin_serial_reg, &bfin_serial_ports[i].port);
bfin_serial_ports[i].port.dev = NULL;
-#if defined(CONFIG_SERIAL_BFIN_CTSRTS) || \
- defined(CONFIG_SERIAL_BFIN_HARD_CTSRTS)
+#if defined(CONFIG_SERIAL_BFIN_CTSRTS)
gpio_free(bfin_serial_ports[i].cts_pin);
gpio_free(bfin_serial_ports[i].rts_pin);
#endif
--
1.6.6
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
