Re: Gap not retransmitted after switchover

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Vlad!

I made quite a lot of tests today. Here are my results.

When I repeated my previous test (IPv4 addresses only) I did not experience any problems. So, it seems that the patch worked! The server, after receiving three consecutive SACKs with the reported gap (three miss indications), it retransmitted the missing TSNs and the data flow continued normally. I repeated it many times and the result was always the same.

However, I experienced the same problem (not always but some times) when I had the following setup.
- Server having both IPv4 and IPv6 addresses on ethernet interface.
- Client having IPv6 on ethernet (X) and IPv4 on wlan (Y).
- Association established with all the above addresses belonging to the association. The client uses its IPv6 address to contact the IPv6 address of the server (initially), so the initial handshake is done using the IPv6 addresses. The client sends an ASCONF just after association establishment to tell the server to set its primary to the X. - Whenever the ethernet cable is removed at the client, the client calls setsockopt(SET_PEER_PRIMARY_ADDR) to tell the server to set Y as its primary and then calles sctp_bindx() to remove X from the association. In this scenario, sometimes the server does not retransmit the gap (after changing primary from X to Y and deleting Y from association).

Another observation that I have made, is that sometimes, after the ethernet cable is removed and I call setsockopt(SET_PEER_PRIMARY_ADDR) on the client to set the peer's primary to Y, the actual transmission of the ASCONF chunk is observed after many seconds (sometimes I observed the transmission 30 seconds after the call to setsockopt). I don't know if this is normal. Even with IPv4 only test I observed a small delay between calling setsockopt() and observing the ASCONF chunk, but it was about 1-2 seconds. With the IPv4/IPv6 test, this delay varied more.

Looking forward to your comments! Let me know if you want me to test something more.

Best regards,
George



On 05/11/2010 05:35 PM, Vlad Yasevich wrote:


Vlad Yasevich wrote:

Georgios Cheimonidis wrote:
Hi Vlad!

I have repeated the test with the net-next kernel tree. It seems that
the problem persists. Below, I summarize what I observed from the
capture at the server side (the client's capture agrees with these
observations). Although the timing differs somewhat from the previous
test, the basic observation is still the same. After the server switches
primary address and removes the previous primary from the association,
some unacknowledged DATA packets that were transmitted to the previous
primary (after it became unreachable) are never retransmitted to the new
one.


Thanks for testing.  I am looking to see what can be happening.

-vlad


Hi George.

I figured out why there were no retransmits.  Because you changed primary
path, you kicked in the SFR-CACC algorithm, and our implementation didn't
deal properly with the fact that some chunks may have moved from the old
primary to the new one without going though a retransmit.

There are really 2 ways to deal with this:
	1).  If we are deleting a transport that had outstanding data,
	automatically retransmit the data on the new transport.

	or.

	2) Under the same condition as above, move the data to the new primary
	destination and let fast-recovery take care of the issue.

Linux implemented (2) from above, and thus this bug surfaced.

Try the attached patch, and let me know if it fixes it for you.

-vlad

--
To unsubscribe from this list: send the line "unsubscribe linux-sctp" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html

[Index of Archives]     [Linux Networking Development]     [Linux OMAP]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux