On Sun, 28 Aug 2016, Geert Uytterhoeven wrote:
> Hi Finn,
>
> On Sat, Aug 27, 2016 at 4:30 AM, Finn Thain <fthain@xxxxxxxxxxxxxxxxxxx>
> wrote:
> > Large PIO transfers are broken up into chunks to try to avoid
> > disabling local IRQs for long periods. But IRQs are still disabled for
> > too long and this causes SCC FIFO overruns during serial port
> > transfers. This patch fixes the problem by halving the PIO chunk size.
> >
> > Testing with mac_scsi shows that the extra NCR5380_main() loop
> > iterations have negligible performance impact on SCSI transfers (about
> > 1% slower). On a faster system (using the dmx3191d module) transfers
> > showed no measurable change.
> >
> > Signed-off-by: Finn Thain <fthain@xxxxxxxxxxxxxxxxxxx>
> >
> > ---
> > drivers/scsi/NCR5380.c | 6 +++---
> > 1 file changed, 3 insertions(+), 3 deletions(-)
> >
> > Index: linux/drivers/scsi/NCR5380.c
> > ===================================================================
> > --- linux.orig/drivers/scsi/NCR5380.c 2016-08-27 12:29:57.000000000 +1000
> > +++ linux/drivers/scsi/NCR5380.c 2016-08-27 12:29:58.000000000 +1000
> > @@ -1847,11 +1847,11 @@ static void NCR5380_information_transfer
> > /* XXX - need to source or sink data here, as appropriate */
> > }
> > } else {
> > - /* Break up transfer into 3 ms chunks,
> > - * presuming 6 accesses per handshake.
> > + /* Transfer a small chunk so that the
> > + * irq mode lock is not held too long.
> > */
> > transfersize = min((unsigned long)cmd->SCp.this_residual,
> > - hostdata->accesses_per_ms / 2);
> > + hostdata->accesses_per_ms >> 2);
>
> I think it's easier to read if you use "/ 4".
I think the factor, "1/4 byte milliseconds per access" is not very
meaningful. The PIO transfersize can be understood as,
pio_bytes_until_scc_fifo_overflow = accesses_per_ms /
(accesses_per_pio_byte / ms_until_fifo_overflow)
This loop seemed like a good place to avoid a DIV instruction (though I
didn't try to confirm that) and so I used a bit shift to indicate that
intention.
The shift amount was an empirical result that happened to work for the
hardware I tested it on, at the baud rate I was using. Admittedly, if we
want to avoid further tweaks to this then I'll have to do more testing and
find a better approximation.
--
>
> Gr{oetje,eeting}s,
>
> Geert
>
--
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
