Hi James,
We had some performance problems with RAID systems connected to LPe12k.
AFAICS, the reason is a small bug in lpfc.ko, causing the IO-size to
be smaller than expected.
The patch below fixes it for us.
Please CC me, I'm not on the list.
Best regards
Bodo
------------------------------------------------------
From: Bodo Stroesser <bstroesser@xxxxxxxxxxxxxx>
Date: Fri, 29 May 2015 13:34:19 +0200
Subject: [PATCH] lpfc: in sli3 use configured sg_seg_cnt for sg_tablesize
Currently the module parameter lpfc_sg_seg_count does not have effect
for sli3 devices.
In lpfc_sli_driver_resource_setup(), which is used for sli3, the code
writes the configured sg_seg_cnt into lpfc_template.sg_tablesize.
But lpfc_template is the template used for sli4 only. Thus the value should
correctly be written to lpfc_template_s3->sg_tablesize.
This patch is for kernel 4.1-rc5, but is tested with lpfc 10.2.405.26 only.
Signed-off-by: Bodo Stroesser <bstroesser@xxxxxxxxxxxxxx>
---
--- a/drivers/scsi/lpfc/lpfc_init.c 2015-05-29 10:19:02.000000000 +0200
+++ b/drivers/scsi/lpfc/lpfc_init.c 2015-05-29 10:19:56.000000000 +0200
@@ -4988,7 +4988,7 @@ lpfc_sli_driver_resource_setup(struct lp
/* Initialize the host templates the configured values. */
lpfc_vport_template.sg_tablesize = phba->cfg_sg_seg_cnt;
- lpfc_template.sg_tablesize = phba->cfg_sg_seg_cnt;
+ lpfc_template_s3.sg_tablesize = phba->cfg_sg_seg_cnt;
/* There are going to be 2 reserved BDEs: 1 FCP cmnd + 1 FCP rsp */
if (phba->cfg_enable_bg) {
ÿôèº{.nÇ+?·?®??+%?Ëÿ±éݶ¥?wÿº{.nÇ+?·¥?{±þÇ,?ø§¶?¡Ü¨}©?²Æ zÚ&j:+v?¨þø ¯ù ®w¥þ?à2?Þ?¨èÚ&¢)ß¡«a¶Úÿÿûàz¿äz¹Þ?ú+?ù???Ý¢jÿ?wèþf
