Hello
We have an Emulex LPe1150 that is causing FLOGI failure when the driver
is loaded.
We have updated the firmware on the card. It is working ok with an old
HP MSA.
But with an new MD36xxf so dose it not work.
when the lpfc driver is loded so dose it take about 7 seconds to load
and efter that so
do we only see these LUN's: We do not see the other disk LUN's
[16:0:0:0] disk DELL MD36xxf 0784 -
[16:0:0:31] disk DELL Universal Xport 0784 -
dmesg shows this after the driver is loaded.
[15313.555729] scsi12 : Emulex LPe1150 1Gb PCIe Fibre Channel Adapter on
PCI bus 0e device 00 irq 30
[15317.795558] lpfc 0000:0e:00.0: 1:1303 Link Up Event x1 received Data:
x1 x1 x10 x2 x0 x0 0
[15317.795680] lpfc 0000:0e:00.0: 1:1309 Link Up Event npiv not
supported in loop topology
[15317.796111] lpfc 0000:0e:00.0: 1:(0):2858 FLOGI failure Status:x3/x18
TMO:x0
[15317.796423] lpfc 0000:0e:00.0: 1:(0):2858 FLOGI failure Status:x3/x18
TMO:x0
[15317.796726] lpfc 0000:0e:00.0: 1:(0):2858 FLOGI failure Status:x3/x18
TMO:x0
[15317.796825] lpfc 0000:0e:00.0: 1:(0):0100 FLOGI failure Status:x3/x18
TMO:x0
Could it be an bug in the lpfc driver when it is used with MD36xxf?
Any suggestions what to do or try?
I have tried kernel version 3.8.8 and it has the same issue.
Best Johnny
--
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
