Krzysztof Błaszkowski wrote:
On Tuesday 22 December 2009 20:44, Douglas Gilbert wrote:
Krzysztof Błaszkowski wrote:
Hello Eric,
I think it is not necessary and current behavior of kernel like 2.6.31
confuses QA people.
They need explanation that message like below:
sd 5:0:1:0: [sdb] Sense Key : Recovered Error [current] [descriptor]
Descriptor sense data with sense descriptors (in hex):
72 01 00 1d 00 00 00 0e 09 0c 00 00 00 00 00 00
00 00 00 00 00 50
sd 5:0:1:0: [sdb] Add. Sense: ATA pass through information available
stands for that sense data contains ata registers file and the command
was executed properly.
Here is additional condition i used in scsi_io_completion() which
suppresses this message. Is it okay ?
Close but I would like to see a filter on the additional
sense code ATA PASS-THROUGH INFORMATION AVAILABLE [0x0, 0x1d].
There is nothing in SAT that precludes the return of a RECOVERED
ERROR sense code for a read on a SATA disk that was recovered
after some extra work (for example).
of course but is it good idea to log sense data if:
- it is created on demand by application. (sat-2 ch 12.2.2 and .3)
- it doesn't contain some failure status
?
With that filter in place there is no need to filter on the command.
right but OTOH if filter used asc/ascq then it would filter out all commands
even these with some failures.
i am not sure if this is really what you want to have, ie block all dumps of
ATA PASS-THROUGH sense data.
IOWs just filter on sense code RECOVERED ERROR and additional
sense code ATA PASS-THROUGH INFORMATION AVAILABLE. SAT and SAT-2
compliant implementations should then dump less to the log.
i would say that asc/ascq filter will stop logging all SAT/SAT-2 check
conditions instead of "less".
that improvement i sent has better "granularity".
I disagree.
This is the code sequence I had in mind:
if (sense_valid && (sshdr.sense_key == RECOVERED_ERROR)) {
/* if ATA PASS-THROUGH INFORMATION AVAILABLE skip
* print since app wants ATA registers */
if ((sshdr.asc == 0x0) && (sshdr.ascq == 0x1d))
;
else if (!(req->cmd_flags & REQ_QUIET))
scsi_print_sense("", cmd);
result = 0;
/* BLOCK_PC may have set error */
error = 0;
}
This will suppress logging the sense data associated with the
ATA PASS-THROUGH INFORMATION AVAILABLE additional sense code.
That is only generated in the situation when a SCSI ATA PASS-THROUGH
command sets the CK_COND bit _and_ there was no other error from
the ATA disk or the transport (e.g. SAS can issue an ABORTED COMMAND
sense key). This is shown in sat2r09.pdf section 12.2.5 table 113.
Doug Gilbert
P.S. Haven't seen Eric Youngdale's email address for a while
--
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
