On Tue, 08 Dec 2009 15:38:12 -0600
"Stephen M. Cameron" <scameron@xxxxxxxxxxxxxxxxxx> wrote:
> Use msleep() instead of schedule_timeout
msleep() does set_current_state() itself.
--- a/drivers/scsi/hpsa.c~hpsa-use-msleep-instead-of-schedule_timeout-fix
+++ a/drivers/scsi/hpsa.c
@@ -1949,7 +1949,6 @@ static int wait_for_device_to_become_rea
/* Wait for a bit. do this first, because if we send
* the TUR right away, the reset will just abort it.
*/
- set_current_state(TASK_UNINTERRUPTIBLE);
msleep(1000 * waittime);
count++;
@@ -2838,7 +2837,6 @@ static __devinit int hpsa_message(struct
tag = readl(vaddr + SA5_REPLY_PORT_OFFSET);
if (HPSA_TAG_DISCARD_ERROR_BITS(tag) == paddr32)
break;
- set_current_state(TASK_UNINTERRUPTIBLE);
msleep(HPSA_MSG_SEND_RETRY_INTERVAL_MSECS);
}
@@ -2952,7 +2950,6 @@ static __devinit int hpsa_hard_reset_con
pmcsr |= PCI_D3hot;
pci_write_config_word(pdev, pos + PCI_PM_CTRL, pmcsr);
- set_current_state(TASK_UNINTERRUPTIBLE);
msleep(500);
/* enter the D0 power management state */
@@ -2960,7 +2957,6 @@ static __devinit int hpsa_hard_reset_con
pmcsr |= PCI_D0;
pci_write_config_word(pdev, pos + PCI_PM_CTRL, pmcsr);
- set_current_state(TASK_UNINTERRUPTIBLE);
msleep(500);
/* Restore the PCI configuration space. The Open CISS
@@ -3187,7 +3183,6 @@ static int hpsa_pci_init(struct ctlr_inf
scratchpad = readl(h->vaddr + SA5_SCRATCHPAD_OFFSET);
if (scratchpad == HPSA_FIRMWARE_READY)
break;
- set_current_state(TASK_UNINTERRUPTIBLE);
msleep(HPSA_BOARD_READY_POLL_INTERVAL_MSECS);
}
if (scratchpad != HPSA_FIRMWARE_READY) {
@@ -3262,7 +3257,6 @@ static int hpsa_pci_init(struct ctlr_inf
if (!(readl(h->vaddr + SA5_DOORBELL) & CFGTBL_ChangeReq))
break;
/* delay and try again */
- set_current_state(TASK_UNINTERRUPTIBLE);
msleep(10);
}
@@ -3302,7 +3296,6 @@ static int __devinit hpsa_init_one(struc
/* Some devices (notably the HP Smart Array 5i Controller)
need a little pause here */
- set_current_state(TASK_UNINTERRUPTIBLE);
msleep(HPSA_POST_RESET_PAUSE_MSECS);
/* Now try to get the controller to respond to a no-op */
diff -puN drivers/scsi/hpsa.h~hpsa-use-msleep-instead-of-schedule_timeout-fix drivers/scsi/hpsa.h
_
--
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
