Brian, You should get a tool for HBA parameter configuration, or you can directly change the code of setting SAS address in last function of mv_spi.c. Regards Andy Yan -----Original Message----- From: Foster_Brian@xxxxxxx [mailto:Foster_Brian@xxxxxxx] Sent: 2009年6月9日 21:03 To: Andy Yan; vst@xxxxxxxx Cc: linux-scsi@xxxxxxxxxxxxxxx; scst-devel@xxxxxxxxxxxxxxxxxxxxx; James.Bottomley@xxxxxxxxxxxxxxxxxxxxx Subject: RE: [ANNOUNCE]: A target driver for Marvell 88SE64xx(3G) and 88SE94xx(6G) SAS cards > Brian, > Please set unique SAS address for each SAS port of target > controller, and make sure you do correct connection, you can get the SAS > address of attaching device from "attach sas address ".Then enable target > mode and add target LUN. > > Regards > Andy Yan > Not quite sure I follow... Is this value read from HW at init time? Do we have an interface available where I can explicitly set a SAS address for the port? Thanks. Brian ?韬{.n?????%??檩??w?{.n???{炳??Ф?塄}?财??j:+v?? ? ???2??璀??摺?囤??z夸z罐?+?????w棹f
