From: Lalit Chandivade <lalit.chandivade@xxxxxxxxxx>
Use minimum value for max vport during firmware initialization in LOOP
topology. Using max vport value from get resource count in LOOP topology
causes firmware initialization failure.
Signed-off-by: Lalit Chandivade <lalit.chandivade@xxxxxxxxxx>
Signed-off-by: Andrew Vasquez <andrew.vasquez@xxxxxxxxxx>
---
drivers/scsi/qla2xxx/qla_init.c | 6 +++++-
1 files changed, 5 insertions(+), 1 deletions(-)
diff --git a/drivers/scsi/qla2xxx/qla_init.c b/drivers/scsi/qla2xxx/qla_init.c
index 9865017..14325c0 100644
--- a/drivers/scsi/qla2xxx/qla_init.c
+++ b/drivers/scsi/qla2xxx/qla_init.c
@@ -1308,8 +1308,12 @@ qla2x00_init_rings(scsi_qla_host_t *vha)
DEBUG(printk("scsi(%ld): Issue init firmware.\n", vha->host_no));
- if (ha->flags.npiv_supported)
+ if (ha->flags.npiv_supported) {
+ if (ha->operating_mode == LOOP)
+ ha->max_npiv_vports = MIN_MULTI_ID_FABRIC - 1;
mid_init_cb->count = cpu_to_le16(ha->max_npiv_vports);
+ }
+
mid_init_cb->options = __constant_cpu_to_le16(BIT_1);
--
1.6.2.rc0.55.g30aa4f
--
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
