Hi Neil,
Thanks for your comment.
On 1/16/2025 5:28 PM, Neil Armstrong wrote:
Hi,
[+linux-arm-msm@xxxxxxxxxxxxxxx]
On 16/01/2025 10:11, Ziqi Chen wrote:
With OPP V2 enabled, devfreq can scale clocks amongst multiple frequency
plans. However, the gear speed is only toggled between min and max during
clock scaling. Enable multi-level gear scaling by mapping clock
frequencies
to gear speeds, so that when devfreq scales clock frequencies we can put
the UFS link at the appropraite gear speeds accordingly.
This series has been tested on below platforms -
SM8650 + UFS3.1
Which board did you use ? the MTP ? >
We tested on MTP.
SM8750 + UFS4.0
Did you alse test it on SM8550 ? this platform is also concerned.
And perhaps SM8450 should be also converted to the OPP table & tested.
We didn't test in on SM8550 before, but now we already tested it on
SM8550 once see you this comment. It works fine on SM8550 as well.
I will update this information in next version.
Please Cc linux-arm-msm on all patches since we're directly concerned by
the whole changeset.
Sure , Thank you for reminder, I will CC this group from next version.
Thanks,
Neil
-Ziqi
Can Guo (6):
scsi: ufs: core: Pass target_freq to clk_scale_notify() vops
scsi: ufs: qcom: Pass target_freq to clk scale pre and post change
scsi: ufs: core: Add a vops to map clock frequency to gear speed
scsi: ufs: qcom: Implement the freq_to_gear_speed() vops
scsi: ufs: core: Enable multi-level gear scaling
scsi: ufs: core: Toggle Write Booster during clock scaling base on
gear speed
Ziqi Chen (2):
scsi: ufs: core: Check if scaling up is required when disable clkscale
ARM: dts: msm: Use Operation Points V2 for UFS on SM8650
arch/arm64/boot/dts/qcom/sm8650.dtsi | 51 ++++++++++++++++----
drivers/ufs/core/ufshcd-priv.h | 17 +++++--
drivers/ufs/core/ufshcd.c | 71 +++++++++++++++++++++-------
drivers/ufs/host/ufs-mediatek.c | 1 +
drivers/ufs/host/ufs-qcom.c | 60 ++++++++++++++++++-----
include/ufs/ufshcd.h | 8 +++-
6 files changed, 166 insertions(+), 42 deletions(-)
