On 2022/6/16 0:21, Bart Van Assche wrote:
On 6/15/22 08:34, Chao Yu wrote:
As SCSI SBC4 specification section 5.30.2 describes that it can
support unmapping one or more LBA range in single UNMAP command,
however, previously we only pack one LBA range in UNMAP command
by default no matter device gives the block limits that says it
can support in-batch UNMAP.
The above sentence is too long. Please split it.
This patch tries to set max_discard_segments config according to
^^^^^^^^^^^^
Consider changing "tries to set" into "sets".
block limits of device, and supports in-batch UNMAP.
Consider changing "in-batch UNMAP" into "unmapping multiple LBA ranges with a single UNMAP command".
+ blk_queue_max_discard_segments(q, sdkp->max_block_desc_count);
sdkp->max_block_desc_count is 32 bits wide while blk_queue_max_discard_segments() accepts an unsigned short as second argument. So the value 0x10002 will be converted into 2, which is not correct. Consider changing the second argument into min(U16_MAX, sdkp->max_block_desc_count).
sdkp->provisioning_mode = mode;
switch (mode) {
@@ -836,9 +837,10 @@ static blk_status_t sd_setup_unmap_cmnd(struct scsi_cmnd *cmd)
struct scsi_device *sdp = cmd->device;
struct request *rq = scsi_cmd_to_rq(cmd);
struct scsi_disk *sdkp = scsi_disk(rq->q->disk);
- u64 lba = sectors_to_logical(sdp, blk_rq_pos(rq));
- u32 nr_blocks = sectors_to_logical(sdp, blk_rq_sectors(rq));
- unsigned int data_len = 24;
+ unsigned short segments = blk_rq_nr_discard_segments(rq);
+ unsigned int data_len = 8 + 16 * segments;
+ unsigned int data_offset = 8;
Please rename 'data_offset' into 'descriptor_offset' to match the SBC-4 terminology.
@@ -2870,9 +2879,9 @@ static void sd_read_block_limits(struct scsi_disk *sdkp)
goto out;
lba_count = get_unaligned_be32(&vpd->data[20]);
- desc_count = get_unaligned_be32(&vpd->data[24]);
+ sdkp->max_block_desc_count = get_unaligned_be32(&vpd->data[24]);
Consider adding /* Extract the MAXIMUM UNMAP BLOCK DESCRIPTOR COUNT. */ above the above statement.
diff --git a/drivers/scsi/sd.h b/drivers/scsi/sd.h
index 5eea762f84d1..bda9db5e2322 100644
--- a/drivers/scsi/sd.h
+++ b/drivers/scsi/sd.h
@@ -119,6 +119,7 @@ struct scsi_disk {
u32 opt_xfer_blocks;
u32 max_ws_blocks;
u32 max_unmap_blocks;
+ u32 max_block_desc_count;
I do not agree with the choice of the name of this member variable. The name used in SBC-4 is "MAXIMUM UNMAP BLOCK DESCRIPTOR COUNT". Leaving out "unmap" when abbreviating that description into a member name makes it impossible to guess what the purpose of that member variable is.
Agreed, thanks for the review. I've updated the patch as you suggested.
Thanks,
Thanks,
Bart.
