On Fri, Feb 23, 2018 at 5:36 PM, Arnd Bergmann <arnd@xxxxxxxx> wrote:
> 32-bit architectures generally cannot use writeq(), so we now get a build
> failure for the lpfc driver:
>
> drivers/scsi/lpfc/lpfc_sli.c: In function 'lpfc_sli4_wq_put':
> drivers/scsi/lpfc/lpfc_sli.c:145:4: error: implicit declaration of function 'writeq'; did you mean 'writeb'? [-Werror=implicit-function-declaration]
>
> Another problem here is that writing out actual data (unlike accessing
> mmio registers) means we must write the data with the same endianess
> that we have read from memory, but writeq() will perform byte swaps
> and add barriers inbetween accesses as we do for registers.
>
> Using memcpy_toio() should do the right thing here, using register
> sized stores with correct endianess conversion and barriers (i.e. none),
> but on some architectures might fall back to byte-size access.
>
> Side note: shouldn't the driver use ioremap_wc() instead of ioremap()
> to get a write-combining mapping on all architectures that support this?
IIRC memcpy_toio() doesn't increment the destination address.
lo_hi or hi_lo helpers sound better.
> Fixes: 1351e69fc6db ("scsi: lpfc: Add push-to-adapter support to sli4")
> Signed-off-by: Arnd Bergmann <arnd@xxxxxxxx>
> @@ -115,7 +115,6 @@ lpfc_sli4_wq_put(struct lpfc_queue *q, union lpfc_wqe *wqe)
> struct lpfc_register doorbell;
> uint32_t host_index;
> uint32_t idx;
> - uint32_t i = 0;
> uint8_t *tmp;
>
> /* sanity check on queue memory */
> @@ -138,12 +137,10 @@ lpfc_sli4_wq_put(struct lpfc_queue *q, union lpfc_wqe *wqe)
> if (q->phba->sli3_options & LPFC_SLI4_PHWQ_ENABLED)
> bf_set(wqe_wqid, &wqe->generic.wqe_com, q->queue_id);
> lpfc_sli_pcimem_bcopy(wqe, temp_wqe, q->entry_size);
> - if (q->dpp_enable && q->phba->cfg_enable_dpp) {
> + if (q->dpp_enable && q->phba->cfg_enable_dpp)
> /* write to DPP aperture taking advatage of Combined Writes */
> - tmp = (uint8_t *)wqe;
> - for (i = 0; i < q->entry_size; i += sizeof(uint64_t))
> - writeq(*((uint64_t *)(tmp + i)), q->dpp_regaddr + i);
> - }
> + memcpy_toio(tmp, q->dpp_regaddr, q->entry_size);
> +
> /* ensure WQE bcopy and DPP flushed before doorbell write */
> wmb();
>
> --
> 2.9.0
>
--
With Best Regards,
Andy Shevchenko
