ufshcd_link_startup() can call ufshcd_vops_link_startup_notify()
multiple times when retrying. This causes the phy reference count
to keep increasing and the phy to not properly re-initialize.
If the phy has already been previously powered on, first issue a
phy_power_off() and phy_exit(), before re-initializing and powering
on again.
Signed-off-by: Peter Griffin <peter.griffin@xxxxxxxxxx>
Fixes: 3d73b200f989 ("scsi: ufs: ufs-exynos: Change ufs phy control sequence")
Cc: stable@xxxxxxxxxxxxxxx
---
drivers/ufs/host/ufs-exynos.c | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/drivers/ufs/host/ufs-exynos.c b/drivers/ufs/host/ufs-exynos.c
index 61b03e493cc1ddba17179a9f22e5b59ece02458b..34e16e198830d086cbdb6cb0b027ca92687b2ae6 100644
--- a/drivers/ufs/host/ufs-exynos.c
+++ b/drivers/ufs/host/ufs-exynos.c
@@ -962,6 +962,12 @@ static int exynos_ufs_phy_init(struct exynos_ufs *ufs)
}
phy_set_bus_width(generic_phy, ufs->avail_ln_rx);
+
+ if (generic_phy->power_count) {
+ phy_power_off(generic_phy);
+ phy_exit(generic_phy);
+ }
+
ret = phy_init(generic_phy);
if (ret) {
dev_err(hba->dev, "%s: phy init failed, ret = %d\n",
--
2.49.0.rc1.451.g8f38331e32-goog
