ETIMEDOUT is more specific than EIO, use it for
wait_for_completion_timeout().
Reviewed-by: Sam Protsenko <semen.protsenko@xxxxxxxxxx>
Signed-off-by: Tudor Ambarus <tudor.ambarus@xxxxxxxxxx>
---
drivers/spi/spi-s3c64xx.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
index 4cafec877931..bcc00cb5e0d1 100644
--- a/drivers/spi/spi-s3c64xx.c
+++ b/drivers/spi/spi-s3c64xx.c
@@ -566,7 +566,7 @@ static int s3c64xx_wait_for_dma(struct s3c64xx_spi_driver_data *sdd,
/*
* If the previous xfer was completed within timeout, then
- * proceed further else return -EIO.
+ * proceed further else return -ETIMEDOUT.
* DmaTx returns after simply writing data in the FIFO,
* w/o waiting for real transmission on the bus to finish.
* DmaRx returns only after Dma read data from FIFO which
@@ -587,7 +587,7 @@ static int s3c64xx_wait_for_dma(struct s3c64xx_spi_driver_data *sdd,
/* If timed out while checking rx/tx status return error */
if (!val)
- return -EIO;
+ return -ETIMEDOUT;
return 0;
}
@@ -617,7 +617,7 @@ static int s3c64xx_wait_for_pio(struct s3c64xx_spi_driver_data *sdd,
if (use_irq) {
val = msecs_to_jiffies(ms);
if (!wait_for_completion_timeout(&sdd->xfer_completion, val))
- return -EIO;
+ return -ETIMEDOUT;
}
val = msecs_to_loops(ms);
--
2.43.0.687.g38aa6559b0-goog
