The current interconnect provider registration interface is inherently racy as nodes are not added until the after adding the provider. This can specifically cause racing DT lookups to fail: of_icc_xlate_onecell: invalid index 0 cpu cpu0: error -EINVAL: error finding src node cpu cpu0: dev_pm_opp_of_find_icc_paths: Unable to get path0: -22 qcom-cpufreq-hw: probe of 18591000.cpufreq failed with error -22 Switch to using the new API where the provider is not registered until after it has been fully initialised. Fixes: 5bc9900addaf ("interconnect: qcom: Add OSM L3 interconnect provider support") Cc: stable@xxxxxxxxxxxxxxx # 5.7 Signed-off-by: Johan Hovold <johan+linaro@xxxxxxxxxx> --- drivers/interconnect/qcom/osm-l3.c | 14 ++++++-------- 1 file changed, 6 insertions(+), 8 deletions(-) diff --git a/drivers/interconnect/qcom/osm-l3.c b/drivers/interconnect/qcom/osm-l3.c index 5fa171087425..3a1cbfe3e481 100644 --- a/drivers/interconnect/qcom/osm-l3.c +++ b/drivers/interconnect/qcom/osm-l3.c @@ -158,8 +158,8 @@ static int qcom_osm_l3_remove(struct platform_device *pdev) { struct qcom_osm_l3_icc_provider *qp = platform_get_drvdata(pdev); + icc_provider_deregister(&qp->provider); icc_nodes_remove(&qp->provider); - icc_provider_del(&qp->provider); return 0; } @@ -245,14 +245,9 @@ static int qcom_osm_l3_probe(struct platform_device *pdev) provider->set = qcom_osm_l3_set; provider->aggregate = icc_std_aggregate; provider->xlate = of_icc_xlate_onecell; - INIT_LIST_HEAD(&provider->nodes); provider->data = data; - ret = icc_provider_add(provider); - if (ret) { - dev_err(&pdev->dev, "error adding interconnect provider\n"); - return ret; - } + icc_provider_init(provider); for (i = 0; i < num_nodes; i++) { size_t j; @@ -275,12 +270,15 @@ static int qcom_osm_l3_probe(struct platform_device *pdev) } data->num_nodes = num_nodes; + ret = icc_provider_register(provider); + if (ret) + goto err; + platform_set_drvdata(pdev, qp); return 0; err: icc_nodes_remove(provider); - icc_provider_del(provider); return ret; } -- 2.39.1