Hi Krzysztof,
> > +/* External sdcard */
> > +&mmc_2 {
> > + status = "okay";
> > + bus-width = <4>;
> > + cap-sd-highspeed;
> > + card-detect-delay = <200>;
> > + pinctrl-0 = <&sd2_clk &sd2_cmd &mmc2_cd &sd2_bus1 &sd2_bus4>;
> > + pinctrl-names = "default";
> > + samsung,dw-mshc-ciu-div = <3>;
> > + samsung,dw-mshc-ddr-timing = <0 2>;
> > + samsung,dw-mshc-sdr-timing = <0 4>;
> > + sd-uhs-sdr50;
> > + vmmc-supply = <&ldo19_reg>;
> > + vqmmc-supply = <&ldo13_reg>;
> > +};
> > +
> > +&pinctrl_0 {
> > + mmc2_cd: sd2-cd-pins {
> > + samsung,pins = "gpx2-4";
>
> Interesting... I looked at vendor sources to board-chagall and standard
> pin gpc2-2 is mentioned as PULL down and not-connected comment.
>
> gpx2-4 seems not mentioned at all, unless other board files are actually
> used.
Gpio seems to be spread out. GPIO_T_FLASH_DETECT is defined as gpx2-4
in board-universal5420-mmc.c, and then used for card detection.
(Looking at it now again I see that write protection through sd2_wp
should also be supported for mmc_2, can add that in next patch set.)
> Anyway, if it works for you, it's good.
>
> Rest looks ok, I'll apply after the merge window.
Thanks!
> Best regards,
> Krzysztof
Best regards,
Henrik Grimler
